Owner's Manual

MS 201, MS 201 C
English
36
Short-term storage
Wait for engine to cool down. Keep the
machine with a full tank of fuel in a dry
place, well away from sources of
ignition, until you need it again.
Long-term storage
See "Storing the machine"
Varying cutting lengths, types of wood
and work techniques require varying
amounts of oil.
The oil flow can be adjusted as needed
using the adjusting screw (1) on the top
of the machine.
Ematic position (E), medium oil flow –
N Turn adjusting screw to "E" (Ematic
position)
To increase oil flow –
N turn the adjusting screw clockwise
To reduce oil flow –
N turn the adjusting screw
counterclockwise
N Turn the bar over – every time you
sharpen the chain and every time
you replace the chain – this helps
avoid one-sided wear, especially at
the nose and underside of the bar.
N Regularly clean the oil inlet hole (1),
the oilway (2) and the bar
groove (3).
N Measure the groove depth – with
the scale on the filing gauge (special
accessory) – in the area used most
for cutting.
Oil Quantity Control
The chain must always be coated
with oil.
1
0011BA034 KN
Taking Care of the Guide
Bar
2
3
1
143BA026 KN