Owner's Manual

MS 201, MS 201 C
English
34
For all versions
N Push the hand guard (1) forwards –
the chain is blocked
N Simultaneously press the throttle
trigger lockout (2) and throttle
trigger (3) – set master control
lever (4)
Position cold start l
– If engine is cold (even if the engine
has stalled during opening of
throttle after starting)
Position warm start n
– If engine is warm (once the engine
has been running for approx. one
minute)
N Hold and start the chain saw
When the engine has turned over for
the first time
N Move the Master Control lever (1) to
the position warm start n
N Hold and start the chain saw
Once the engine is running
N Press the throttle trigger lockout and
blip the throttle trigger (2); the
master control lever (1) jumps to
run F and the engine begins to idle
N Pull the hand guard toward the
handlebar
The chain brake is released – the chain
saw is ready for use.
At very low temperatures
N Let the engine warm up briefly with
the throttle slightly open
N If necessary, configure for winter
operation – see "Winter Operation"
Switching off the engine
N Move the master control lever to the
stop position 0
If the Master Control lever was moved
from the position warm start n to stop 0
– afterwards simultaneously press the
throttle trigger lockout and the throttle
trigger.
1
2
3
4
0011BA011 KN
STOP
1
0011BA012 KN
STOP
2
1
0011BA013 KN
STOP
Open the throttle only when the
chain brake is off. Increased
engine speeds with the chain
brake on (saw chain is stationary)
will quickly damage the clutch and
chain brake.
0011BA001 KN