Instruction Manual

MS 201 C-M
English
55
EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Engine
Single cylinder two-stroke engine
Ignition System
Electronic magneto ignition
Fuel System
All position diaphragm carburetor with
integral fuel pump
Chain Lubrication
Fully automatic, speed-controlled oil
pump. Additional manual oil flow control
Weight
Cutting Attachments
Recommended cutting attachments
conforming with the 45 degree
computed kickback angle requirement
of Section 5.11 of
ANSI/OPEI B175.1-2012 when used on
this model chain saw (see the chapter
on "Safety Precautions and Working
Techniques"):
Rollomatic E guide bars
Actual cutting length will be less than
listed bar length.
Carving E guide bars
Actual cutting length will be less than
listed bar length.
Saw chain 3/8" P
Specifications
A = 300 hours
B = 125 hours
C = 50 hours
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Displacement: 2.15 cu.in
(35.2 cc)
Bore: 1.60 in (40 mm)
Stroke: 1.10 in (28 mm)
Engine power to ISO
7293:
2.4 bhp (1.8 kW)
at 10,500 rpm
Idle speed: 3,000 rpm
Max. permissible
speed (with cutting
attachment): 14,000 rpm
Spark plug (resistor
type): NGK CMR 6 H
Electrode gap: 0.02 in (0.5 mm)
Fuel tank capacity: 10.5 fl.oz (0.31 l)
Oil tank capacity: 7.4 fl.oz (0.22 l)
dry, without bar and chain
MS 201 C-M: 9.0 lbs (4.1 kg)
Reduced kickback STIHL guide bars
(with green label)
Bar lengths: 30, 35, 40 cm (12, 14,
16 in.)
Pitch: 3/8" P (9.32 mm)
Groove width: 1.3 mm (0.050 in)
Sprocket nose: 9-tooth
Reduced kickback STIHL guide bars
(with green label)
Bar lengths: 30 cm (12 in.)
Pitch: 1/4" (6.35 mm)
Groove width: 1.3 mm (0.05 in)
Low kickback STIHL saw chain (with
green label)
Picco Micro 3 (63 PM3) Type 3636
Picco Super 3 (63 PS3) Type 3616
Picco Duro 3 (63 PD3) Type 3612
Pitch: 3/8" P (9.32 mm)
Drive link gauge: 1.3 mm (0.05 in)
STIHL saw chain (with yellow label)
Picco Super (63 PS) Type 3617
Picco Micro (63 PM) Type 3613
Pitch: 3/8" P (9.32 mm)
Drive link gauge: 1.3 mm (0.05 in)