Instruction Manual

MS 201 C-M
English
38
Version with Easy2Start
N Pull the starter grip slowly and
steadily with your right hand and
push down the front handle at the
same time. Do not pull out the
starter rope all the way – it might
otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Starting the Saw
WARNING
Bystanders must be well clear of the
general work area of the saw.
Version with Easy2Start
N Press the manual fuel pump bulb at
least five times – even if the bulb is
already filled with fuel.
All models
N Push the hand guard (1) forward –
the chain is locked.
The Master Control lever (4) is in the
normal run position F.
N If the engine is cold: Press down the
trigger lockout (2) and pull the
throttle trigger (3) at the same time.
Hold both levers in that position and
set the Master Control lever (4) to
start symbol }.
N Hold your saw firmly.
N Pull the starter grip quickly and
firmly as often as necessary until the
engine starts.
N If the engine does not start: Move
the Master Control lever (4) to start
position } and repeat starting
procedure.
As soon as the engine runs
N If the engine was started in the start
position }: Press down trigger
lockout (1) and the pull the throttle
trigger (2) at the same time – the
Master Control lever (3) moves to
the run position F and the engine
settles down to idling speed.
N Pull the hand guard back towards
the front handle.
The chain brake is now disengaged –
your saw is ready for operation.
NOTICE
Always disengage chain brake before
accelerating the engine. High revs with
the chain brake engaged (chain locked)
will quickly damage the clutch and chain
brake.
0011BA010 KN
1
2
3
4
0011BA050 KN
1
2
3
0011BA051 KN
0011BA041 KN