Owner's Manual

MS 192 T, MS 192 TC
English
29
As the chain brake is still engaged, the
engine must be returned to idling speed
immediately or the engine housing and
chain brake might otherwise be
damaged.
N Pull the hand guard back toward the
handlebar. The chain brake is now
disengaged – your saw is ready for
operation.
Always disengage chain brake before
accelerating the engine. High revs with
the chain brake engaged (chain locked)
will quickly damage the powerhead and
chain drive (clutch, chain brake).
N Always check operation of chain
lubrication before starting work.
At very low outside temperatures
N Open throttle slightly – warm up the
engine for a short period.
Shutting down the engine
N Move the Master Control lever to 0
or STOP.
If fuel tank has been run completely dry
and then refueled
N After refueling, press the fuel pump
bulb at least five times – even if the
bulb is filled with fuel.
If the engine does not start
Engine is flooded
If you did not move the choke lever to
warm start j quickly enough after the
engine began to fire, the combustion
chamber is flooded.
N Move the Master Control lever to 0
or STOP.
N Open the twist lock (1) in the
direction of the arrow.
N Remove the carburetor box
cover (2).
N Insert a suitable tool in the spark
plug boot (3).
N Pry off the spark plug boot.
N Unscrew and dry off the spark plug.
N Open the throttle wide.
N Set the choke lever to j (warm
start).