Owner's Manual

29MS 191 T
English / USA
: Set the choke lever (5) to:
for cold start l
for warm start j
(also use this position if engine has
been running but is still cold)
: Place your saw on solid ground.
: Make sure you have a firm footing –
check that chain is not touching any
object or the ground.
Bystanders must be well clear of the
general work area of the saw.
: Hold the saw firmly on the ground
with your right hand on the top
handle and your right knee resting
on the filter cover.
: Pull the starter grip slowly with your
left hand until you feel it engage –
then give the grip a brisk strong pull
and push down the top handle at the
same time.
: Do not pull out the starter rope to its
full length – it might otherwise
break.
: Do not let the starter grip snap back
– guide it back slowly and vertically
so that the starter rope can rewind
properly.
If the engine is new, pull the starter
several times to prime the fuel system.
5
170BA013 KN
1
70BA014 KN
1
70BA014 KN