Instruction Manual

Choke shutter open (j)
3006BA022 KN
–
if engine is warm (once the engine has been
running for approx. one minute)
► Hold and start your saw as described.
15.8 When Engine Begins to Fire
3006BA022 KN
► Move the choke lever to the open posi‐
tion (j ).
► Hold and start your saw as described.
15.9 As Soon As the Engine Runs
3006BA008 KN
4
3
► Press down the trigger lockout and blip the
throttle trigger (3) – the Master Control
lever (4) moves to the run position (F) and the
engine settles down to idling speed.
3006BA001 KN
► Pull the hand guard toward the control handle
to disengage the chain brake.
NOTICE
Open the throttle only when the chain brake is
off. Increased engine speeds with the chain
brake on (saw chain is stationary) will quickly
damage the clutch and chain brake.
► After a cold start, warm up the engine at vary‐
ing speeds – your saw is ready for operation.
15.10 At Very Low Outside Tempera‐
tures
In case of erratic idling behaviour or poor accel‐
eration
► Readjust carburetor if necessary, see "Adjust‐
ing the Carburetor".
► If your saw is very cold (frost or ice on
machine), start the engine and keep it at a
high idle speed (with chain brake disengaged)
until it reaches normal operating temperature.
15.11 Shut off the engine
► Move Master Control lever to Stop
0.
15.12 If Engine Does Not Start
If you did not move the Master Control lever from
the choke closed position (l) to the choke open
position (j) quickly enough after the engine
began to fire, the engine is probably flooded.
► Move Master Control lever to Stop
0.
15 Starting / Stopping the Engine English
0458-508-0121-B 19