Instruction Manual

MF-MM
English
7
Operation
N Secure the handlebar in the normal
operating position.
N Start the engine.
N Work with the engine running at full
throttle.
N Walk at a pace that achieves the
required result without lugging down
the engine.
N Operate at no more than a normal
walking pace.
Cleaning the Dethatcher
Parts of plants, such as grass or roots,
may become tightly wound around the
tool mounting and the attachment itself.
Clean the attachment as follows:
– Shut off the engine.
– Wear work gloves.
– Remove the inner hitch pins from
the shaft.
– Pull the dethatcher off the shaft.
– Remove the outer hitch pin (wheel)
from the shaft.
– Pull off the wheel.
– Remove pieces of roots, plants and
soil.
Refer to "Mounting the MultiTool" for
mounting instructions.
Only use MultiEngines supplied by
STIHL or expressly approved by STIHL
for use with the MultiTool.
This MultiTool may only be used in
combination with the STIHL MM 55
MultiEngine.
Removing Existing MultiTools
WARNING
Wear gloves to reduce the risk of injury
from contact with sharp MultiTools
and/or hot surface of gearbox.
N Remove the hitch pins and pull the
MultiTools (if fitted) off the axle –
see also "Mounting the MultiTool" in
the instruction manual of the other
MultiTool.
N Clean the gearbox if necessary.
Approved MultiEngines Mounting the MultiTool
481BA008 KN