Instruction Manual

MF-MM
English
11
N Check that the MultiTool is not
touching the ground or any other
obstacles. The unit must rest on the
engine flange and the support on
the frame.
N Make sure you have good balance
and secure footing – as shown in the
illustration.
WARNING
To reduce the risk of injury from contact
with the rotating attachment, always
stand to the side of the power tool, never
in front of the attachment.
N With your left hand on the loop
handle, press the unit firmly against
the ground – do not touch the
throttle trigger or lockout lever.
NOTICE
Do not stand or kneel on the handlebar
or frame.
WARNING
The attachment may begin to move as
soon as the engine starts. For this
reason, blip the throttle after starting –
the engine returns to idling speed.
Now follow the starting procedure
described in the MultiEngine instruction
manual.
Stopping the Engine
N See MultiEngine instruction manual.
Replace individual spring tines if they
are severely damaged or broken.
N Remove the dethatcher – see
"Mounting the MultiTool".
N Loosen the screws (1) on the
dethatcher.
N Remove the flange (2).
Spring tines and washers are fitted
alternately on the tubes.
N Pull off the spring tines (3) and
washers.
N Replace damaged spring tines.
N Fit spring tines and washers on the
tubes until they are full.
N Fit the flange (2).
N Tighten down the screws (1) firmly.
N Mount the dethatcher – see
"Mounting the MultiTool".
For periods of 3 months or longer
N Remove, clean and inspect the
dethatcher with deflector extensions
and mud flap.
N Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
Replacing Spring Tines
483BA006 KN
1
2
3
1
Storing the Machine