Instruction Manual

KM 94 R
English
16
Starting the engine
N Press the fuel pump bulb (5) at least
5 times - even when bulb is filled
with fuel
N Turn throttle set wheel as far as
possible in the direction+
Cold engine (cold start)
N Turn the choke knob (6) and then
press to g
Also use this setting if the engine has
been running but is still cold.
Hot engine (hot start)
N The choke knob (6) remains in
position F
Cranking
N Place the machine on the ground so
that it rests securely on the engine
support:
N (if present): Remove the transport
guard on the cutting attachment
The working tool must not touch the
ground or any other objects – see also
"Starting / stopping the engine" in the
KombiTool Instruction Manual – risk of
accident!
N safe standing - possibilities:
standing, bent or kneeling
N Press the machine firmly against the
ground with the left hand – do not
touch the throttle trigger, throttle
trigger lockout or momentary stop
switch while doing so
NOTICE
Do not stand or kneel on the shaft!
N Grab the starter grip with your right
hand
N Pull the starter grip slowly until you
feel it engage and then give it a
brisk, strong pull
NOTICE
Do not pull out the starter rope
completely – risk of breakage!
N Do not let the starter grip snap back
– guide it slowly back into the
housing so that the starter rope can
rewind properly
N actuate until the engine starts!
Once the engine is running
At temperatures below +10 °C (+50 °F)
Allow the machine to warm up in
position g for at least 10 seconds.
At temperatures over +10 °C (+50 °F)
Allow the machine to warm up in
position g for approx. 5 seconds.
5
0000-GXX-5224-A0
2.
1.
6
0000-GXX-5475-A0
192BA002 KN
192BA003 KN