Instruction Manual

KM 94 R
English
15
N If your fuel cap still does not tighten
properly, it may be damaged or
broken. Stop using the power tool
and take it to your authorized STIHL
dealer for repair or replacement.
Operating elements
1 Throttle trigger lockout
2 Throttle trigger
3 Momentary stop switch – with
settings for Run and Stop. To switch
off the ignition system, the stop
switch (…) must be pressed – see
"Function of the stop switch and the
ignition"
4 Throttle set wheel – to limit the
throttle path – see "Function of the
thumb wheel"
Function of the momentary stop switch
and the ignition
If the momentary stop switch is
actuated, the ignition is switched off and
the engine is switched off. When
released, the momentary stop switch
automatically returns to the Run
position: After the engine has stopped,
the ignition is automatically switched on
again in the Run position – the engine is
ready for starting and can be started.
Function of the throttle set wheel
The throttle set wheel (4) is used to set
the throttle path infinitely between idling
and full throttle and therefore also the
engine speed range:
– Turn throttle set wheel (4) in –
direction: the throttle path is shorter
and the set maximum engine speed
is lower
– Turn throttle set wheel (4) in +
direction: the throttle path is longer
and the set maximum engine speed
is higher
– Press the throttle trigger forcefully to
apply full throttle even if limitation
set– the set limitation is maintained–
when the throttle trigger is released,
it is back in the preset range.
Starting / Stopping the
Engine
192BA001 KN
2
1
4
3
0208BA067 KN
4