Instruction Manual

KM 94 R
English
11
The following STIHL KombiTools may
be mounted on the KombiMotor:
A barrier bar is supplied with the
machine. Fit the barrier bar on the loop
handle.
N Fit the square nuts (1) in the barrier
bar (2); the holes must line up.
N Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
N Position the clamp (6) against the
drive tube.
N Place the barrier bar (2) in position
as shown.
N Line up the holes.
N Insert the screws (7) in the holes
and screw them into the barrier
bar (2) as far as stop.
N Go to "Adjusting and Securing the
Loop Handle".
Approved KombiTools
KombiTool
1)
the barrier bar supplied with the
machine must be used – see also
"Mounting the Loop Handle"
Application
FS-KM Brushcutter with
mowing head
FS-KM
1)
Brushcutter with
grass cutting blade
FSB-KM Brushcutter with
mowing head
RG-KM
1)
Weeder
HL-KM 145° Long reach hedge
trimmer, adjustable
HL-KM 0° Long reach hedge
trimmer
FH-KM 145° Power scythe
BG-KM Blower
HT-KM Pole pruner
BF-KM Cultivator
FBD-KM Redefining bed
edges
FCB-KM Lawn edging
FCS-KM
2)
2)
If the FCS-KM is used with the
KM 94 R, a flexible shaft must be
installed in place of the rigid shaft.
Lawn edging
KB-KM Bristle brush
KW-KM PowerSweep
Mounting the Loop Handle
2
1
1
002BA647 KN
2
5
4
3
6
7
002BA648 KN