Instruction Manual

KB-MM, KW-MM
English
10
Fitting New Deflector
N Line up the deflector (5) on the
flange (6) and push it onto the drive
tube as far as stop.
N Tighten down the clamp screws (7)
firmly.
Mounting the Gearbox
N Push the gearbox (2) onto the drive
tube as far as stop while turning it
back and forth.
N Line up the gearbox.
N Go to "Checking Position of
Gearbox".
Checking Position of Gearbox
WARNING
To reduce risk of injury from the
MultiTool rotating in the wrong direction,
check that position of gearbox is correct
and adjust if necessary.
The axle (1) must be above the shaft (2).
Direction of rotation (3) of MultiTool.
Adjusting Position of Gearbox
N Loosen clamp screws on gearbox.
N Turn the gearbox through 180°.
N Line up the gearbox in the correct
position.
N Tighten down the two clamp screws
on the gearbox in the following
sequence:
– Tighten the first screw moderately.
– Tighten the second screw
moderately.
– Tighten down first screw firmly.
– Tighten down second screw firmly.
NOTICE
It must not be possible to rotate the
gearbox on the drive tube.
Mounting the MultiTool
N Push the grass shield (1) onto the
axle (2) as far as stop.
N Push the axle (2) onto the drive
shaft (3) as far as stop.
N Insert and engage the pin (4) in the
axle and through the drive shaft.
7
7
5
486BA014 KN
6
1
1
2
486BA015 KN
469BA044 KN
1
2
486BA007 KN
4
2
3
486BA008 KN