Operation Manual

HTA 65, HTA 85
English
70
Battery
The machine may be operated only with
original STIHL AP and AR rechargeable
batteries.
Power tool running time is dependent on
the energy content of the battery.
Chain Lubrication
Fully automatic speed-controlled oil
pump with reciprocating piston
Weight
Cutting Attachment
Actual cutting length may be less than
the specified length
Rollomatic E Mini guide bars
1/4" P chains
Chain sprocket
Noise and Vibration Data
Noise and vibration data are determined
on the basis of the rated maximum
speed.
For further details on compliance with
Vibration Directive 2002/44/EC see
www.stihl.com/vib/
Sound pressure level L
p
to ISO 22868
Sound power level L
w
to ISO 22868
Vibration measurement a
hv
to
ISO 22867
The K-factor in accordance with
Directive 2006/42/EC is 2.5 dB(A) for
the sound pressure level and sound
power level; the K-factor in accordance
with Directive 2006/42/EC is 2.0 m/s
2
for the vibration measurement.
Transport
STIHL batteries fulfill the requirements
stated in UN-Manual
ST/SG/AC.10/11/Rev.5 Part III,
Subsection 38.3.
The user can transport STIHL batteries
by road transport to the place where the
machine is to be used without additional
requirements.
The lithium ion batteries included are
subject to the provisions of the
legislation relating to dangerous goods.
When shipped by a third party (e. g. air
transport or haulage firm), special
packaging and identification
requirements must be observed.
When preparing the item for shipment, a
dangerous goods expert must be
consulted. Please observe any further
national regulations.
Pack the battery so that it cannot move
inside the packaging.
Further transport instructions - see
www.stihl.com/safety-data-sheets
REACH
REACH is an EC regulation and stands
for the Registration, Evaluation,
Authorisation and Restriction of
Chemical substances.
For information on compliance with the
REACH regulation (EC) No. 1907/2006
see www.stihl.com/reach.
Specifications
Type: Lithium-ion
Designation: AP, AR
Oil tank capacity: 105 cc (0.105 l)
without cutting attachment, without
battery
HTA 65: 3.4 kg
HTA 85: 4.5 kg
Cutting length: 25, 30 cm
Pitch: 1/4" P (6.35 mm)
Groove width: 1.1 mm
Picco Micro Mini 3 (71 PMM3)
Type 3670
Pitch: 1/4" P (6.35 mm)
Drive link gauge: 1.1 mm
6-tooth for 1/4" P
HTA 65: 76 dB(A)
HTA 85: 76 dB(A)
HTA 65: 93 dB(A)
HTA 85: 93 dB(A)
Handle, left Handle, right
HTA 65: 2.5 m/s
2
2.5 m/s
2
HTA 85: 1.0 m/s
2
1.0 m/s
2