Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing Pole Pruner for Operation
- 6 Charging the Battery, LEDs
- 7 Assembling the Pole Pruner
- 8 Removing and Fitting the Battery
- 9 Switching Pole Pruning On and Off
- 10 Checking Pole Pruner and Battery
- 11 Using the Pole Pruner
- 12 After Finishing Work
- 13 Transporting
- 14 Storing
- 15 Cleaning
- 16 Maintenance
- 17 Repairing
- 18 Troubleshooting
- 19 Specifications
- 20 Bar and Chain Combinations
- 21 Combinations of Carrying Systems
- 22 Spare Parts and Accessories
- 23 Disposal
- 24 EC Declaration of Conformity
- 25 General Power Tool Safety Warnings
0458-698-0121-A
24
English
11 Using the Pole Pruner
► Press clip (1) together and move on the handle hose (2),
ensuring that the following conditions are met:
– If the shaft has been retracted: a = 15 cm
– If the shaft has been fully extended: b = 50 cm
11.3 Fitting and Adjusting the Shoulder Strap
► Put on the shoulder strap (1).
► Adjust the shoulder strap (1) so that the carabiner (2) is
about a hand’s width below your right hip.
Other approved carrying systems are listed in this User
Manual, @ 21.1.
11.4 Holding and Controlling the Pole Pruner
► Connect the carrying ring (2) to the carabiner (1).
► Hold the pole pruner with one hand by the control handle
– wrap your thumb around the control handle.
► Hold the pole pruner firmly with your other hand by the
handle hose - wrap your thumb around the handle hose.
a
b
2
1
0000097174_001
2
1
0000-GXX-2990-A0
1
2
0000097177_001
0000097178_001