Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing Pole Pruner for Operation
- 6 Charging the Battery, LEDs
- 7 Assembling the Pole Pruner
- 8 Removing and Fitting the Battery
- 9 Switching Pole Pruning On and Off
- 10 Checking Pole Pruner and Battery
- 11 Using the Pole Pruner
- 12 After Finishing Work
- 13 Transporting
- 14 Storing
- 15 Cleaning
- 16 Maintenance
- 17 Repairing
- 18 Troubleshooting
- 19 Specifications
- 20 Bar and Chain Combinations
- 21 Combinations of Carrying Systems
- 22 Spare Parts and Accessories
- 23 Disposal
- 24 EC Declaration of Conformity
- 25 General Power Tool Safety Warnings
0458-698-0121-A
16
English
7 Assembling the Pole Pruner
7.1 Assembling the Pole Pruner
► Switch off the pole pruner and remove the battery.
► Remove the protective cap (1).
► Adjust the shaft length to a = 10 cm.
► Mark b = 6 cm on the shaft (2).
► Align the collet (4) and transmission (3) as shown.
► Slide the transmission (3) onto the shaft (2) up to mark b.
► Tighten down the screws (5) firmly.
► If you cannot push the transmission (3) onto the shaft (2)
up to mark b:
► Rotate the nut (7) counterclockwise until the chain
sprocket cover (6) can be removed.
► Remove the chain sprocket cover (6).
► Turn the chain sprocket (8) and push the transmission
(3) onto shaft (2) up to mark b.
► Fit the chain sprocket cover (6) so that it is flush with the
pole pruner.
► Fit the nut (7) and tighten it down firmly.
► Undo the screws (9).
► Pull out the protective tube (10).
7 Assembling the Pole Pruner
b
1
2
3
a
0000097972_001
90°
4
3
90°
5
0000098531_001
7
6
8
0000098623_001
10
9
0000097324_001