Operation Manual

40
english
HT 70, HT 75
: File the top of the depth gauge
parallel to the stamped service
marking (see arrow) – but do not
lower the highest point of the depth
gauge in this process.
The kickback tendency of the
chainsaw is increased if the depth
gauges are too low.
: Place filing gauge on the chain –
highest point of depth gauge must
be level with the filing gauge.
After sharpening
After sharpening, clean the chain
thoroughly, remove filings or grinding
dust – lubricate the chain thoroughly.
Before long out-of-service period
Clean the chain with a brush and store it
in a well-oiled condition.
Information for re-ordering chain
Sharpening Toools
(special accessories)
689BA044 KN
689BA052 KN
Type: Picco Micro Mini
Pitch: 3/8" P (9.32 mm)
Number of tie
straps: 44
Cutting length: 12" (30 cm)
Description Part No.
Round file
5/32" (4.0 mm)
diameter 5605 772 4006
File holder 5605 750 4327
Filing gauge 0000 893 4000
Flat file 0814 252 3356
Sharpening kit
(includes all parts
listed above) 5605 007 1026