Operation Manual

24
English / USA
HT 100, HT 101, HT 130, HT 131
The saw chain must always throw off a
small amount of oil.
: Always check chain lubrication and
the oil level in the tank before
starting work.
Never operate your pruner without
chain lubrication. If the chain is run
dry, the whole cutting attachment
will be irretrievably damaged within
a very short time.
Inadequate lubrication can be caused by
a dirty oil strainer: Have the oil strainer
cleaned or replaced by your servicing
dealer.
Every new chain has to be broken in
for about 2 to 3 minutes.
After breaking in the chain, check
chain tension and adjust if
necessary – see chapter
"Checking Chain Tension".
Always shut off the engine and fit the
chain guard
: Loosen the screw.
: Adjust shaft to the required length.
: Tighten the screw firmly.
Shoulder strap*
: Put on the shoulder strap (1).
: Adjust length of strap so that the
spring hook (2), with the unit
attached, is at about the same
height as your right hip.
* see "Guide to Using this Manual"
Checking Chain Lubrication
390BA048 KN
Adjusting the Telescopic
Shaft
(HT 101, HT 131)
390BA049 KN
Fitting the Harness
2
1
390BA040 KN