Owner's Manual

15HT 73
english / USA
Flush-cutting thick branches
If branch diameter is more than
4" (10 cm), first perform undercut (3)
and cross-cut at a distance (A) of about
8" (20 cm) from the final cut. Then carry
out the flush-cut (4), starting with a
relieving cut and finishing with a cross-
cut.
: Unscrew nut and take off cover.
: Turn tensioning screw (1)
counterclockwise until the
: tensioning nut (2) butts against the
left end of the housing slot.
The chain is very sharp – wear work
gloves to protect hands from cuts.
: Fit the chain –
start at the bar nose.
3
4
A
390BA024 KN
Mounting the Bar and Chain
243BA002 KN
1
2
243BA003 KN
390BA003 KN