Owner's Manual

HT 56 C
English
25
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
N Continue cranking until the engine
runs.
As soon as the engine runs
N Press down the throttle trigger
lockout and open the throttle – the
choke lever moves to the run
position F . After a cold start, warm
up the engine by opening the
throttle several times.
Your machine is now ready for
operation.
Shut off the engine
N Move the stop switch in the direction
of 0 – the engine stops – release
the stop switch – it springs back to
the run position.
Other hints on starting
Engine stalls in cold start position g
or under acceleration
N Move the choke lever to < and
continue cranking until the engine
runs.
Engine does not start in warm start
position <
N Move the choke lever to g and
continue cranking until the engine
runs.
If the engine does not start
N Check that all settings are correct.
N Check that there is fuel in the tank
and refuel if necessary.
N Check that the spark plug boot is
properly connected.
N Repeat the starting procedure.
Fuel tank run until completely dry
N After refueling, press the fuel pump
bulb at least five times – even if the
bulb is filled with fuel.
N Set the choke lever to suit the
engine temperature.
N Start the engine.
The unit features a split drive tube that
helps save space during transportation.
Disconnecting the Drive Tube
N Disconnect the shoulder strap from
the carrying ring.
N Place the unit on the ground:
N Loosen the star knob (1) – do not
remove it.
N Pull the front drive tube (2) out of the
coupling sleeve (3).
Make sure the carburetor is
correctly adjusted. The saw chain
must not move when the engine is
idling.
547BA021 KN
Transporting the Unit
4907BA004 KN
1
4907BA005 KN
3
2