Owner's Manual

HT 56 C
English
24
Controls
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and 0 =Stop
positions.
Function of stop switch and ignition
system
The stop switch is normally in the Run
position: Ignition is on in this position –
the engine is ready to start and may be
started. If the stop switch is moved to
the 0 position, the ignition is switched
off. It is automatically switched on again
after the engine comes to a standstill.
Starting the engine
N Press the fuel pump bulb (4) at least
five times – even if the bulb is
already filled with fuel.
Cold engine (cold start)
N Press in the choke lever (5) and turn
it to g at the same time.
Warm engine (warm start)
N Press in the choke lever (5) and turn
it to < at the same time.
Also use this setting if the engine has
been running but is still cold.
Cranking
N Remove the chain guard.
N Place the unit on the ground: It must
rest securely on the engine support
and the hook. If necessary, rest the
hook on a raised support (e.g. a
branch, mound or something
similar). Check that the chain is not
touching any object or the ground.
N Make sure you have a firm footing.
N Hold the unit firmly on the ground
with your left hand and press down
– do not touch the throttle trigger or
throttle trigger lockout.
N Hold the starter grip with your right
hand.
N Pull the starter grip steadily.
Starting / Stopping the
Engine
3
1
2
4907BA001 KN
4
547BA015 KN
5
547BA016 KN
5
547BA017 KN
Check that nobody is standing
within the working range of the
pruner.
Do not stand or kneel on the drive
tube.
Do not pull out the starter rope all
the way – it might otherwise
break.
275BA007 KN