Owner's Manual

HT 56 C
English
16
30° angle drive (special accessory)
The angle drive keeps the cutting
attachment at an angle of 30° to the
drive tube.
The angle drive may be adjusted on the
drive tube to the following positions only:
1 For cross-cutting vertical branches
and bushes.
2 For a better view of the cutting
attachment.
The unit features a split drive tube that
helps save space during transportation.
It unit can be easily disassembled for
transportation – see "Transporting the
Unit".
Connecting the Drive Tube
N Pull the cap (1) off the end of the
front drive tube and keep it in a safe
place for later use – see "Storing the
Machine".
N Put the powerhead on the ground so
that it rests on the machine support.
N Slide the lug (2) on the front drive
tube (3) into the slot (4) in the
coupling sleeve as far as stop – if
necessary, turn the front drive
tube (3) back and forth while
pushing it home.
When correctly installed, the red
line (5) (arrow point) must be flush with
the end of the coupling sleeve.
N Tighten down the star knob (6)
firmly.
N Attach the shoulder strap to the
carrying ring.
1
2
390BA053 KN
Assembling the Unit
Do not mount KombiTools – only
use the drive tube with splined
shaft supplied with the machine.
4907BA004 KN
1
4907BA008 KN
2
4907BA009 KN
4
3
6
5
4907BA010 KN