Operation Manual

HT 102, HT 103, HT 132, HT 133
English
22
N Place the cap on the opening and
rotate it counterclockwise until it
engages the filler neck.
N Continue rotating the cap
counterclockwise (about a quarter
turn) – this causes the bottom of the
cap to be turned to the correct
position.
N Turn the cap clockwise and lock it in
position – see section on "Closing".
The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate your machine without
chain lubrication. If the chain runs dry,
the whole cutting attachment will be
irretrievably damaged within a very short
time. Always check chain lubrication and
the oil level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
WARNING
Always shut off the engine and fit the
chain guard
N Loosen the clamp nut half a turn
counterclockwise.
N Adjust shaft to the required length.
N Tighten down the clamp nut firmly.
Left: Bottom of cap is twisted –
inner mark (1) in line with
outer mark.
Right: Bottom of cap in correct posi-
tion – inner mark is under the
grip. It is not in line with the
outer mark.
002BA584 KN
1
0000-GXX-0136-A0
Checking Chain Lubrication
246BA027 KN
Adjusting the Telescoping
Shaft
0000-GXX-1566-A0