Operation Manual

0458-722-9621-A
43
English 15 Maintenance
14.2 Cleaning the Cutting Blades
► Switch off the hedge trimmer, move retaining latch to
position
and pull the connecting cable plug out of the socket.
► Spray both sides of blades with STIHL resin solvent.
► Insert the connecting cable plug.
► Run the hedge trimmer for 5 seconds, .
The cutting blades run. STIHL resin solvent is distributed
evenly.
15.1 Maintenance Intervals
The maintenance intervals are dependent on the
environmental and operating conditions. STIHL
recommends the following maintenance intervals:
After every 50 hours of operation
► Lubricate the gearbox.
15.2 Lubricating the Gearbox
► Remove the screw plug (1).
► If no grease can be seen on the end of the screw plug (1):
► Screw the tube (2) of STIHL lubricant into the filler hole.
► Squeeze 5 g of STIHL gear lubricant into the gearbox.
► Unscrew the tube (2) of STIHL gear lubricant.
► Refit and tighten down the screw plug (1) firmly.
► Run the hedge trimmer for 1 minute.
STIHL gear lubricant is distributed evenly.
15.3 Sharpening the Cutting Blades
STIHL recommends you have the cutting blades
resharpened by a STIHL servicing dealer.
► Use a STIHL flat crosscut file to sharpen each cutting
edge on the upper blade. The file only sharpens on the
forward stroke. Maintain the prescribed sharpening angle,
@ 18.2.
► Turn the hedge trimmer over.
► File the remaining cutting edges.
► Deburr each cutting edge from below.
► Turn the hedge trimmer over.
► Deburr the remaining cutting edges.
► Use a damp cloth to remove the filing dust.
► If you have any queries: Contact your STIHL servicing
dealer.
16.1 Repairing Hedge Trimmer and Cutting Blades
The hedge trimmer and cutting blades cannot be repaired by
the user.
15 Maintenance
1
0000-GXX-2918-A0
2
16 Repairing
0000-GXX-1426-A0