Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 General Power Tool Safety Warnings
- 6 IMPORTANT SAFETY INSTRUCTIONS
- 7 Maintenance, Repair and Storage
- 8 Battery Safety
- 9 Before Starting Work
- 10 Charging the Battery
- 11 LED Diagnostics and Acoustic Signals
- 12 Using a Battery Harness
- 13 Adjusting the Hedge Trimmer
- 14 Inserting and Removing the Connecting Cord
- 15 Switching the Hedge Trimmer On and Off
- 16 Checking the Hedge Trimmer
- 17 During Operation
- 18 After Finishing Work
- 19 Transporting
- 20 Storing
- 21 Cleaning
- 22 Inspection and Maintenance
- 23 Troubleshooting Guide
- 24 Specifications
- 25 Replacement Parts and Equipment
- 26 Disposal
- 27 Limited Warranty
- 28 Trademarks
- 29 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 Advertencias generales de seguridad para herramientas motorizadas
- 6 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 7 Mantenimiento, reparación y almacenamiento
- 8 Seguridad de la batería
- 9 Antes de empezar a trabajar
- 10 Carga de la batería
- 11 Diagnóstico por LED y señales acústicas
- 12 Uso de un arnés para batería
- 13 Ajuste del cortasetos
- 14 Inserción y retiro del cable de conexión
- 15 Encendido y apagado del cortasetos
- 16 Comprobación del cortasetos
- 17 Durante el funcionamiento
- 18 Después de completar el trabajo
- 19 Transporte
- 20 Almacenamiento
- 21 Limpieza
- 22 Inspección y mantenimiento
- 23 Guía de solución de problemas
- 24 Especificaciones
- 25 Piezas y equipos de repuesto
- 26 Eliminación
- 27 Garantía limitada
- 28 Marcas comerciales
- 29 Direcciones
0458-005-8621-A
37
English
23 Troubleshooting Guide
Cutting blades are
not clean and
lubricated.
► Clean the cutting blades, @ 21.2.
► If the LEDs still flash, do not attempt to use.
The hedge trimmer has a malfunction and must be checked
by a servicing dealer.
Hedge trimmer cuts
out during operation.
1 LED glows
red.
Battery too hot / too
cold.
► Remove the connecting cord, @ 14.2.
► Allow the hedge trimmer and battery to cool down gradually
at ambient temperatures of about 50 °F to 68 °F (10 °C to
20 °C).
3 LEDs glow
red.
Hedge trimmer too
hot.
Run-time is too short. Battery not fully
charged.
► Charge the battery as described in its instruction manual.
Useful life of battery
has been reached or
exceeded.
► Have the battery checked by an authorized STIHL servicing
dealer.
Always remove the connecting cord before carrying out any inspection, cleaning or maintenance.
Condition LEDs on
Battery
Cause Remedy