Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 General Power Tool Safety Warnings
- 6 IMPORTANT SAFETY INSTRUCTIONS
- 7 Maintenance, Repair and Storage
- 8 Battery Safety
- 9 Before Starting Work
- 10 Charging the Battery
- 11 LED Diagnostics and Acoustic Signals
- 12 Using a Battery Harness
- 13 Adjusting the Hedge Trimmer
- 14 Inserting and Removing the Connecting Cord
- 15 Switching the Hedge Trimmer On and Off
- 16 Checking the Hedge Trimmer
- 17 During Operation
- 18 After Finishing Work
- 19 Transporting
- 20 Storing
- 21 Cleaning
- 22 Inspection and Maintenance
- 23 Troubleshooting Guide
- 24 Specifications
- 25 Replacement Parts and Equipment
- 26 Disposal
- 27 Limited Warranty
- 28 Trademarks
- 29 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 Advertencias generales de seguridad para herramientas motorizadas
- 6 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 7 Mantenimiento, reparación y almacenamiento
- 8 Seguridad de la batería
- 9 Antes de empezar a trabajar
- 10 Carga de la batería
- 11 Diagnóstico por LED y señales acústicas
- 12 Uso de un arnés para batería
- 13 Ajuste del cortasetos
- 14 Inserción y retiro del cable de conexión
- 15 Encendido y apagado del cortasetos
- 16 Comprobación del cortasetos
- 17 Durante el funcionamiento
- 18 Después de completar el trabajo
- 19 Transporte
- 20 Almacenamiento
- 21 Limpieza
- 22 Inspección y mantenimiento
- 23 Guía de solución de problemas
- 24 Especificaciones
- 25 Piezas y equipos de repuesto
- 26 Eliminación
- 27 Garantía limitada
- 28 Marcas comerciales
- 29 Direcciones
0458-005-8621-A
36
English
23 Troubleshooting Guide
23.1 Hedge Trimmer
23 Troubleshooting Guide
Always remove the connecting cord before carrying out any inspection, cleaning or maintenance.
Condition LEDs on
Battery
Cause Remedy
Hedge Trimmer does
not start when
switched on.
No electrical contact
between hedge
trimmer and battery.
► Remove the connecting cord, @ 14.2.
► Visually check the electrical contacts in the socket.
► Reinsert the connecting cord, @ 14.1.
► If the hedge trimmer still does not start, clean the contact
surfaces on the connecting cord, @ 21.3.
1 LED flashes
green.
STIHL AR only:
Additionally,
four long beeps
are emitted.
Battery has low
charge.
► Charge the battery as described in its instruction manual.
1 LED glows
red.
Battery too hot / too
cold.
► Allow the battery to warm up or cool down gradually at
ambient temperatures of about 50 °F to 68 °F (10 °C to
20 °C).
4 LEDs flash
red.
STIHL AR only:
Additionally, a
rapid
succession of
short beeps is
emitted.
Malfunction in
battery.
► Remove and reinsert the connecting cord, @ 14.
► Switch on the hedge trimmer, @ 15.1.
► If the LEDs continue to flash, do not attempt to use.
The battery has a malfunction and must be replaced.
3 LEDs glow
red.
Hedge trimmer too
hot.
► Allow the hedge trimmer to cool down.
3 LEDs flash
red.
Malfunction in hedge
trimmer.
► Remove and reinsert the connecting cord, @ 14.
► Switch on the hedge trimmer, @ 15.1.
► If the LEDs still flash, do not attempt to use.
The hedge trimmer has a malfunction and must be checked
by a servicing dealer.