Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 General Power Tool Safety Warnings
- 6 IMPORTANT SAFETY INSTRUCTIONS
- 7 Maintenance, Repair and Storage
- 8 Battery Safety
- 9 Before Starting Work
- 10 Charging the Battery
- 11 LED Diagnostics and Acoustic Signals
- 12 Using a Battery Harness
- 13 Adjusting the Hedge Trimmer
- 14 Inserting and Removing the Connecting Cord
- 15 Switching the Hedge Trimmer On and Off
- 16 Checking the Hedge Trimmer
- 17 During Operation
- 18 After Finishing Work
- 19 Transporting
- 20 Storing
- 21 Cleaning
- 22 Inspection and Maintenance
- 23 Troubleshooting Guide
- 24 Specifications
- 25 Replacement Parts and Equipment
- 26 Disposal
- 27 Limited Warranty
- 28 Trademarks
- 29 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 Advertencias generales de seguridad para herramientas motorizadas
- 6 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 7 Mantenimiento, reparación y almacenamiento
- 8 Seguridad de la batería
- 9 Antes de empezar a trabajar
- 10 Carga de la batería
- 11 Diagnóstico por LED y señales acústicas
- 12 Uso de un arnés para batería
- 13 Ajuste del cortasetos
- 14 Inserción y retiro del cable de conexión
- 15 Encendido y apagado del cortasetos
- 16 Comprobación del cortasetos
- 17 Durante el funcionamiento
- 18 Después de completar el trabajo
- 19 Transporte
- 20 Almacenamiento
- 21 Limpieza
- 22 Inspección y mantenimiento
- 23 Guía de solución de problemas
- 24 Especificaciones
- 25 Piezas y equipos de repuesto
- 26 Eliminación
- 27 Garantía limitada
- 28 Marcas comerciales
- 29 Direcciones
0458-005-8621-A
28
English
15 Switching the Hedge Trimmer On and Off
To insert the connecting cord:
► Line up the arrow on the connecting cord plug (1) with the
arrow on the socket (2).
► Push the plug straight into the socket with steady, even
pressure until it is fully inserted.
14.2 Removing the Connecting Cord
WARNING
To reduce the risk of severe personal injury from unintended
activation, always remove the connecting cord before
assembling, transporting, adjusting, cleaning, servicing,
maintaining or storing the hedge trimmer. Remove the
connecting cord in the event of malfunction or emergency
and any time the hedge trimmer is not in use.
WARNING
To reduce the risk of electric shock or personal injury from
the loss of control, always switch off the trimmer before
removing the connecting cord from the socket.
To remove the connecting cord:
► Release trigger switch.
► Pull the plug straight out of the hedge trimmer socket with
steady, even pressure.
NOTICE
Avoid exposing the battery to excessive heat or cold or
prolonged periods of direct sunlight. Use or storage outside
the recommended ambient temperature range can reduce
the performance and/or service life of the battery.
15.1 Switching On
WARNING
To reduce the risk of serious or fatal injuries to the operator
or bystanders from blade contact, keep hands, feet and
other parts of the body away from the cutting blades,
@ 6.5.2. Do not touch the cutting blades while the
connecting cord is inserted. Never touch moving cutting
blades with your hand or any part of your body, @ 6.5.4.
WARNING
Never operate your hedge trimmer if it is modified, damaged,
improperly adjusted or maintained, not completely and
securely assembled or not functioning properly, @ 6.4. To
reduce the risk of personal injury, always wear proper
clothing and protective apparel, including proper eye
protection, when operating your hedge trimmer, @ 6.3. To
reduce the risk of serious or fatal injury from loss of control,
always hold the hedge trimmer with both hands when you
are working, @ 6.5.2.
Before switching on:
► Make sure you have a secure and firm footing.
► Stand upright.
► Always hold and operate the hedge trimmer with one hand
firmly on the rear or control handle and the other hand
firmly on the front or loop handle.
1
0000-GXX-2911-A0
2
15 Switching the Hedge Trimmer On and
Off