Instruction Manual

Table Of Contents
Run the hedge trimmer for 5 seconds, .
The cutting blades run. STIHL resin solvent is
distributed evenly.
14.3 Cleaning the Battery
Clean the battery with a damp cloth.
15 Maintenance
15.1 Maintenance intervals
Maintenance intervals depend on the ambient
conditions and the operating conditions. STIHL
recommends the following maintenance inter‐
vals:
After every 50 hours of operation
Have the gearbox lubricated by a STIHL
dealer.
15.2 Sharpening the cutting blade
STIHL recommends you have the cutting blades
resharpened by a STIHL dealer.
WARNING
The teeth of the cutting blades are very sharp.
This may result in the user cutting themselves.
Wear work gloves made from resistant
material.
Switch off the hedge trimmer, push retaining
latch to position and remove the battery.
0000-GXX-1426-A0
Use a STIHL flat file to sharpen each cutting
edge on the upper blade. The file only sharp‐
ens on the forward stroke. Maintain the pre‐
scribed sharpening angle, 18.2.
Turn the hedge trimmer over.
Sharpen the remaining cutting edges.
Deburr each cutting edge from below.
Turn the hedge trimmer over.
Deburr the remaining cutting edges.
Use a damp cloth to remove the filing dust.
Spray both sides of cutting blades with STIHL
resin solvent.
Run the hedge trimmer for 5 seconds.
The cutting blades run. STIHL resin solvent is
distributed evenly.
If you have any doubts, be sure to consult a
STIHL dealer.
16 Repairing
16.1 Repairing the Hedge Trimmer
and Battery
The hedge trimmer, cutting blades and battery
cannot be repaired by the user.
If the hedge trimmer or cutting blades are
damaged: Do not use your hedge trimmer and
contact your STIHL servicing dealer.
If the battery has a malfunction or is damaged:
Replace the battery.
17 Troubleshooting
17.1 Troubleshooting Hedge Trimmer or Battery
Fault LEDs on the
battery
Cause Remedy
Hedge trimmer
does not start
when switched
on.
1 LED flashing
green.
State of charge of the
battery is too low.
Charge battery as described in the User
Manual for chargers STIHL AL 101, 300,
500.
1 LED emits
red light.
The battery is too
warm or too cold.
Remove the battery.
Allow the battery to cool down or warm
up.
3 LEDs flash
red.
There is a malfunction
in the hedge trimmer.
Remove the battery.
Clean electrical contacts in the battery
compartment.
15 Maintenance English
0458-703-9821-E 29