Operation Manual

0458-714-9621-B
46
English 11 After Finishing Work
► Swing the hedge trimmer from the bottom upwards in an
arc while making the cut.
► Lower the nose of the hedge trimmer without cutting.
► Walk slowly and steadily forwards.
► Swing the hedge trimmer from the bottom upwards in an
arc while making the cut.
► Cut the other side of the hedge in the same way.
► Hold the cutting blades at an angle of 0° to 10° to the top
of the hedge.
► Swing the hedge trimmer horizontally and in an arc while
making the cut.
► If cutting performance deteriorates: Sharpen the cutting
blades.
11.1 After Finishing Work
► Switch off the hedge trimmer, push retaining latch to
position and remove the battery.
► If the hedge trimmer is wet: Allow the hedge trimmer to
dry.
► Clean the hedge trimmer.
► Clean the cutting blades.
► Fit the blade scabbard so that it completely covers the
cutting blades.
► Clean the battery.
12.1 Transporting the Hedge Trimmer
► Switch off the hedge trimmer, push retaining latch to
position and remove the battery.
► Fit the blade scabbard so that it completely covers the
cutting blades.
► Carry the hedge trimmer by the loop handle with the
cutting blades behind you.
► Transporting the hedge trimmer in a vehicle: Secure the
hedge trimmer to prevent it turning over or shifting.
12.2 Transporting the Battery
► Switch off the hedge trimmer, push retaining latch to
position and remove the battery.
► Make sure the battery is in a safe condition.
► Observe the following points when packing the battery:
– The packaging must be non-conductive.
– Make sure the battery cannot shift inside the packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the requirements for the transport
of dangerous goods. The battery is classified as UN 3480
(lithium-ion batteries) and has been tested in accordance
with UN Manual of Tests and Criteria, Part III, sub-section
38.3.
For transport regulations see www.stihl.com/safety-data-
sheets
13.1 Storing the Hedge Trimmer
► Switch off the hedge trimmer, push retaining latch to
position and remove the battery.
► Fit the blade scabbard so that it completely covers the
cutting blades.
11 After Finishing Work
0-10°
0000-GXX-1456-A0
12 Transporting
13 Storing