Instruction Manual
Table Of Contents
- STIHL HSA 56
- 1 Vorwort
- 2 Informationen zu dieser Gebrauchsanleitung
- 3 Übersicht
- 4 Sicherheitshinweise
- 5 Heckenschere einsatzbereit machen
- 6 Akku laden und LEDs
- 7 Akku einsetzen und herausnehmen
- 8 Heckenschere einschalten und ausschalten
- 9 Heckenschere und Akku prüfen
- 10 Mit der Heckenschere arbeiten
- 11 Nach dem Arbeiten
- 12 Transportieren
- 13 Aufbewahren
- 14 Reinigen
- 15 Warten
- 16 Reparieren
- 17 Störungen beheben
- 18 Technische Daten
- 19 Ersatzteile und Zubehör
- 20 Entsorgen
- 21 EU-Konformitätserklärung
- 22 Anschriften
- 23 Allgemeine Sicherheitshinweise für Elektrowerkzeuge
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing Hedge Trimmer for Operation
- 6 Charging the Battery, LEDs
- 7 Removing and Fitting the Battery
- 8 Switching the Hedge Trimmer On/Off
- 9 Testing the Hedge Trimmer and Battery
- 10 Operating the Hedge Trimmer
- 11 After Finishing Work
- 12 Transporting
- 13 Storing
- 14 Cleaning
- 15 Maintenance
- 16 Repairing
- 17 Troubleshooting
- 18 Specifications
- 19 Spare Parts and Accessories
- 20 Disposal
- 21 EC Declaration of Conformity
- 22 General Power Tool Safety Warnings
- 1 Préface
- 2 Informations concernant la présente Notice d'emploi
- 3 Vue d'ensemble
- 4 Prescriptions de sécurité
- 4.1 Symboles d'avertissement
- 4.2 Utilisation conforme à la destination prévue
- 4.3 Exigences posées à l'utilisateur
- 4.4 Vêtements et équipement
- 4.5 Aire de travail et voisinage
- 4.6 Bon état pour une utilisation en toute sécurité
- 4.7 Utilisation
- 4.8 Recharge
- 4.9 Branchement électrique
- 4.10 Transport
- 4.11 Rangement
- 4.12 Nettoyage, entretien et réparation
- 5 Préparatifs avant l'utilisation du taille-haies
- 6 Recharge de la batterie et DEL
- 7 Introduction et extraction de la batterie
- 8 Mise en marche et arrêt du taille-haies
- 9 Contrôle du taille-haies et de la batterie
- 10 Travail avec le taille-haies
- 11 Après le travail
- 12 Transport
- 13 Rangement
- 14 Nettoyage
- 15 Maintenance
- 16 Réparation
- 17 Dépannage
- 18 Caractéristiques techniques
- 19 Pièces de rechange et accessoires
- 20 Mise au rebut
- 21 Déclaration de conformité UE
- 22 Indications générales de sécurité pour outils électroportatifs
- 22.1 Introduction
- 22.2 Sécurité à l'endroit de travail
- 22.3 Sécurité sur le plan électrique
- 22.4 Sécurité des personnes
- 22.5 Utilisation et emploi soigneux d'outils électroportatifs
- 22.6 Utilisation et emploi soigneux d'outils électroportatifs sans fil
- 22.7 Service après-vente
- 22.8 Consignes de sécurité applicables aux taille-haies
- 1 Premessa
- 2 Informazioni sulle presenti Istruzioni d’uso
- 3 Sommario
- 4 Avvertenze di sicurezza
- 4.1 Simboli di avvertimento
- 4.2 Impiego secondo la destinazione
- 4.3 Requisiti dell'utente
- 4.4 Abbigliamento ed equipaggiamento
- 4.5 Zona di lavoro e area circostante
- 4.6 Condizioni di sicurezza
- 4.7 Impiego
- 4.8 Carica
- 4.9 Collegamento elettrico
- 4.10 Trasporto
- 4.11 Conservazione
- 4.12 Pulizia, manutenzione e riparazione
- 5 Preparare il tagliasiepi per l'esercizio
- 6 Carica della batteria e LED
- 7 Inserire e togliere la batteria
- 8 Accendere e spegnere il tagliasiepi
- 9 Controllo di tagliasiepi e batteria
- 10 Lavorare con il tagliasiepi
- 11 Dopo il lavoro
- 12 Trasporto
- 13 Conservazione
- 14 Pulizia
- 15 Manutenzione
- 16 Riparazione
- 17 Eliminazione dei guasti
- 18 Dati tecnici
- 19 Ricambi e accessori
- 20 Smaltimento
- 21 Dichiarazione di conformità UE
- 22 Avvertenze di sicurezza generali per attrezzi elettrici
- 1 Voorwoord
- 2 Informatie met betrekking tot deze handleiding
- 3 Overzicht
- 4 Veiligheidsinstructies
- 5 Heggenschaar klaar maken voor gebruik
- 6 Accu laden en leds
- 7 Accu aanbrengen en wegnemen
- 8 Heggenschaar inschakelen en uitschakelen
- 9 Heggenschaar en accu controleren
- 10 Met de heggenschaar werken
- 11 Na de werkzaamheden
- 12 Vervoeren
- 13 Opslaan
- 14 Reinigen
- 15 Onderhoud
- 16 Repareren
- 17 Storingen opheffen
- 18 Technische gegevens
- 19 Onderdelen en toebehoren
- 20 Milieuverantwoord afvoeren
- 21 EU-conformiteitsverklaring
- 22 Algemene veiligheidswaarschuwingen voor elektrische gereedschappen
Fault LEDs on the
battery
Cause Remedy
No electrical contact
between the hedge
trimmer and battery.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
Hedge trimmer or bat‐
tery damp.
► Allow hedge trimmer or battery to dry.
Hedge trimmer
cuts out during
operation.
3 LEDs light
up red.LEDs
light up red.
Hedge trimmer is too
hot.
► Remove the battery.
► Allow the hedge trimmer to cool down.
There is an electrical
fault.
► Remove battery and reinsert it.
► Switch on the hedge trimmer.
Hedge trimmer
runtime is too
short.
The battery is not fully
charged.
► Fully charge the battery.
The battery service
life has been excee‐
ded.
► Replace battery.
Charging does
not start when
the battery is
inserted into the
charger.
1 LED emits
red light.
The battery is too
warm or too cold.
► Leave battery inserted in charger.
Charging starts automatically as soon as
the permitted temperature range is rea‐
ched.
17.2 Troubleshooting Charger
Condition LED on Char‐
ger
Cause Remedy
Battery not being
charged.
LED flashes
red.
No electrical contact
between charger and
battery.
► Remove the battery.
► Clean contacts on charger.
► Fit the battery.
Malfunction in char‐
ger.
► Do not use the charger and contact your
STIHL servicing dealer.
18 Specifications
18.1 STIHL HSA 56 Hedge Trimmer
–
Approved battery: STIHL AK
–
Weight without battery: 2.9 kg
For battery life see www.stihl.com/battery-life.
18.2 Cutting Blades
–
Tooth spacing: 30 mm
–
Cutting length: 450 mm
–
Sharpening angle: 35°
18.3 STIHL AK Battery
–
Battery technology: Lithium-ion
–
Voltage: 36 V
–
Capacity in Ah: see rating label
–
Energy content in Wh: see rating label
–
Weight in kg: see rating label
–
Permissible temperature range for operation
and storage: -10°C to +50°C
18.4 Charger STIHL AL 101
–
Rated voltage: see rating plate
–
Frequency: see rating plate
–
Rated power: see rating plate
–
Charging current: see rating plate
–
Permissible temperature range for use and
storage: + 5 °C to + 40 °C
The charging times are indicated at
www.stihl.com/charging-times.
18.5 Extension Cords
If an extension cord is used, the cross sectional
area of its conductors must meet the following
minimum requirements – depending on the line
voltage and length of the extension cord:
If rated voltage on the rating label is 220V to
240V:
–
Cord length up to 20 m: AWG 15 / 1.5 mm²
–
Cord length 20 m up to 50 m: AWG 13 /
2.5 mm²
English 18 Specifications
38 0458-714-9621-C