Instruction Manual
Table Of Contents
- STIHL HSA 56
- 1 Vorwort
- 2 Informationen zu dieser Gebrauchsanleitung
- 3 Übersicht
- 4 Sicherheitshinweise
- 5 Heckenschere einsatzbereit machen
- 6 Akku laden und LEDs
- 7 Akku einsetzen und herausnehmen
- 8 Heckenschere einschalten und ausschalten
- 9 Heckenschere und Akku prüfen
- 10 Mit der Heckenschere arbeiten
- 11 Nach dem Arbeiten
- 12 Transportieren
- 13 Aufbewahren
- 14 Reinigen
- 15 Warten
- 16 Reparieren
- 17 Störungen beheben
- 18 Technische Daten
- 19 Ersatzteile und Zubehör
- 20 Entsorgen
- 21 EU-Konformitätserklärung
- 22 Anschriften
- 23 Allgemeine Sicherheitshinweise für Elektrowerkzeuge
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing Hedge Trimmer for Operation
- 6 Charging the Battery, LEDs
- 7 Removing and Fitting the Battery
- 8 Switching the Hedge Trimmer On/Off
- 9 Testing the Hedge Trimmer and Battery
- 10 Operating the Hedge Trimmer
- 11 After Finishing Work
- 12 Transporting
- 13 Storing
- 14 Cleaning
- 15 Maintenance
- 16 Repairing
- 17 Troubleshooting
- 18 Specifications
- 19 Spare Parts and Accessories
- 20 Disposal
- 21 EC Declaration of Conformity
- 22 General Power Tool Safety Warnings
- 1 Préface
- 2 Informations concernant la présente Notice d'emploi
- 3 Vue d'ensemble
- 4 Prescriptions de sécurité
- 4.1 Symboles d'avertissement
- 4.2 Utilisation conforme à la destination prévue
- 4.3 Exigences posées à l'utilisateur
- 4.4 Vêtements et équipement
- 4.5 Aire de travail et voisinage
- 4.6 Bon état pour une utilisation en toute sécurité
- 4.7 Utilisation
- 4.8 Recharge
- 4.9 Branchement électrique
- 4.10 Transport
- 4.11 Rangement
- 4.12 Nettoyage, entretien et réparation
- 5 Préparatifs avant l'utilisation du taille-haies
- 6 Recharge de la batterie et DEL
- 7 Introduction et extraction de la batterie
- 8 Mise en marche et arrêt du taille-haies
- 9 Contrôle du taille-haies et de la batterie
- 10 Travail avec le taille-haies
- 11 Après le travail
- 12 Transport
- 13 Rangement
- 14 Nettoyage
- 15 Maintenance
- 16 Réparation
- 17 Dépannage
- 18 Caractéristiques techniques
- 19 Pièces de rechange et accessoires
- 20 Mise au rebut
- 21 Déclaration de conformité UE
- 22 Indications générales de sécurité pour outils électroportatifs
- 22.1 Introduction
- 22.2 Sécurité à l'endroit de travail
- 22.3 Sécurité sur le plan électrique
- 22.4 Sécurité des personnes
- 22.5 Utilisation et emploi soigneux d'outils électroportatifs
- 22.6 Utilisation et emploi soigneux d'outils électroportatifs sans fil
- 22.7 Service après-vente
- 22.8 Consignes de sécurité applicables aux taille-haies
- 1 Premessa
- 2 Informazioni sulle presenti Istruzioni d’uso
- 3 Sommario
- 4 Avvertenze di sicurezza
- 4.1 Simboli di avvertimento
- 4.2 Impiego secondo la destinazione
- 4.3 Requisiti dell'utente
- 4.4 Abbigliamento ed equipaggiamento
- 4.5 Zona di lavoro e area circostante
- 4.6 Condizioni di sicurezza
- 4.7 Impiego
- 4.8 Carica
- 4.9 Collegamento elettrico
- 4.10 Trasporto
- 4.11 Conservazione
- 4.12 Pulizia, manutenzione e riparazione
- 5 Preparare il tagliasiepi per l'esercizio
- 6 Carica della batteria e LED
- 7 Inserire e togliere la batteria
- 8 Accendere e spegnere il tagliasiepi
- 9 Controllo di tagliasiepi e batteria
- 10 Lavorare con il tagliasiepi
- 11 Dopo il lavoro
- 12 Trasporto
- 13 Conservazione
- 14 Pulizia
- 15 Manutenzione
- 16 Riparazione
- 17 Eliminazione dei guasti
- 18 Dati tecnici
- 19 Ricambi e accessori
- 20 Smaltimento
- 21 Dichiarazione di conformità UE
- 22 Avvertenze di sicurezza generali per attrezzi elettrici
- 1 Voorwoord
- 2 Informatie met betrekking tot deze handleiding
- 3 Overzicht
- 4 Veiligheidsinstructies
- 5 Heggenschaar klaar maken voor gebruik
- 6 Accu laden en leds
- 7 Accu aanbrengen en wegnemen
- 8 Heggenschaar inschakelen en uitschakelen
- 9 Heggenschaar en accu controleren
- 10 Met de heggenschaar werken
- 11 Na de werkzaamheden
- 12 Vervoeren
- 13 Opslaan
- 14 Reinigen
- 15 Onderhoud
- 16 Repareren
- 17 Storingen opheffen
- 18 Technische gegevens
- 19 Onderdelen en toebehoren
- 20 Milieuverantwoord afvoeren
- 21 EU-conformiteitsverklaring
- 22 Algemene veiligheidswaarschuwingen voor elektrische gereedschappen
4.6.4 Charger
The charger is in a safe condition if the following
points are observed:
–
Charger is undamaged.
–
Charger is clean and dry.
WARNING
■
If components do not comply with safety
requirements, they will no longer function
properly and safety devices may be rendered
inoperative. This can result in serious or fatal
injuries.
►
Do not use a damaged charger.
► If the charger is dirty or wet: Clean the
charger and allow it to dry.
► Never attempt to modify the charger.
► Never insert objects in the charger’s open‐
ings.
► Never bridge the charger's contacts with
metallic objects (short circuit).
► Do not open the charger.
4.7 Operation
WARNING
■ The user cannot concentrate on the work in
certain situations. The user may stumble, fall
and be seriously injured.
►
Work calmly and carefully.
► If light and visibility are poor: Do not use
your hedge trimmer.
► Operate the hedge trimmer alone.
► Watch out for obstacles.
► Stand on the ground while working and
keep a good balance. If it is necessary to
work at heights: Use a lift bucket or a safe
platform.
►
If you begin to feel tired: Take a break.
■ Working above shoulder height can cause you
to tire quickly. This can result in serious inju‐
ries.
►
Work above shoulder height for short peri‐
ods only.
► Take regular breaks.
■ If the moving cutting blades make contact with
a hard object they can be brought to a sudden
stop. The reactive forces that occur can cause
the user to lose control of the hedge trimmer
and be seriously injured.
►
Hold the hedge trimmer firmly with both
hands.
► Before starting work, check hedge for hard
objects and remove any such objects.
■ The moving cutting blades can cut the user.
This can result in serious injuries.
► Do not touch moving cutting blades.
► If the cutting blades are blocked by
an object: Switch off the hedge trim‐
mer and remove the battery. Then
remove the object causing the block‐
age.
■
If the behavior of the hedge trimmer changes
during operation or feels unusual, it may no
longer be in a safe condition. This can result in
serious injuries and damage to property.
►
Stop work, remove the battery and contact
your STIHL servicing dealer for assistance.
■ Hedge trimmer vibrations may occur during
operation.
► Wear gloves.
► Take regular breaks.
► If signs of circulation problems occur: Seek
medical advice.
■ Note that the cutting blades continue to run for
about 1 second after you release the trigger.
The moving cutting blades can cut the user.
This can result in serious injuries.
►
Hold the hedge trimmer firmly by the control
handle and loop handle and wait until the
cutting blades come to a complete stand‐
still.
DANGER
■ Working near live electric cables can result in
accidental contact with the cutting blades and
damage the cables. This can result in serious
or fatal injuries.
►
Do not work near live electric cables.
4.8 Charging
WARNING
■
A damaged or defective charger may produce
an unusual smell or emit smoke during the
charging process. This may result in personal
injuries and damage to property.
►
Disconnect the plug from the wall outlet.
■ The charger can overheat and cause a fire if
heat dissipation is inadequate. This can result
in serious or fatal injuries and damage to prop‐
erty.
►
Do not cover the charger.
4.9 Connecting to Power Supply
Contact with live components may occur for the
following reasons:
–
The connecting cable or extension cable is
damaged.
–
Connecting cable plug or extension cable is
damaged.
–
Wall outlet is not properly installed.
4 Safety Precautions English
0458-714-9621-C 29