Instruction Manual
Table Of Contents
- STIHL HSA 56
- 1 Vorwort
- 2 Informationen zu dieser Gebrauchsanleitung
- 3 Übersicht
- 4 Sicherheitshinweise
- 5 Heckenschere einsatzbereit machen
- 6 Akku laden und LEDs
- 7 Akku einsetzen und herausnehmen
- 8 Heckenschere einschalten und ausschalten
- 9 Heckenschere und Akku prüfen
- 10 Mit der Heckenschere arbeiten
- 11 Nach dem Arbeiten
- 12 Transportieren
- 13 Aufbewahren
- 14 Reinigen
- 15 Warten
- 16 Reparieren
- 17 Störungen beheben
- 18 Technische Daten
- 19 Ersatzteile und Zubehör
- 20 Entsorgen
- 21 EU-Konformitätserklärung
- 22 Anschriften
- 23 Allgemeine Sicherheitshinweise für Elektrowerkzeuge
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing Hedge Trimmer for Operation
- 6 Charging the Battery, LEDs
- 7 Removing and Fitting the Battery
- 8 Switching the Hedge Trimmer On/Off
- 9 Testing the Hedge Trimmer and Battery
- 10 Operating the Hedge Trimmer
- 11 After Finishing Work
- 12 Transporting
- 13 Storing
- 14 Cleaning
- 15 Maintenance
- 16 Repairing
- 17 Troubleshooting
- 18 Specifications
- 19 Spare Parts and Accessories
- 20 Disposal
- 21 EC Declaration of Conformity
- 22 General Power Tool Safety Warnings
- 1 Préface
- 2 Informations concernant la présente Notice d'emploi
- 3 Vue d'ensemble
- 4 Prescriptions de sécurité
- 4.1 Symboles d'avertissement
- 4.2 Utilisation conforme à la destination prévue
- 4.3 Exigences posées à l'utilisateur
- 4.4 Vêtements et équipement
- 4.5 Aire de travail et voisinage
- 4.6 Bon état pour une utilisation en toute sécurité
- 4.7 Utilisation
- 4.8 Recharge
- 4.9 Branchement électrique
- 4.10 Transport
- 4.11 Rangement
- 4.12 Nettoyage, entretien et réparation
- 5 Préparatifs avant l'utilisation du taille-haies
- 6 Recharge de la batterie et DEL
- 7 Introduction et extraction de la batterie
- 8 Mise en marche et arrêt du taille-haies
- 9 Contrôle du taille-haies et de la batterie
- 10 Travail avec le taille-haies
- 11 Après le travail
- 12 Transport
- 13 Rangement
- 14 Nettoyage
- 15 Maintenance
- 16 Réparation
- 17 Dépannage
- 18 Caractéristiques techniques
- 19 Pièces de rechange et accessoires
- 20 Mise au rebut
- 21 Déclaration de conformité UE
- 22 Indications générales de sécurité pour outils électroportatifs
- 22.1 Introduction
- 22.2 Sécurité à l'endroit de travail
- 22.3 Sécurité sur le plan électrique
- 22.4 Sécurité des personnes
- 22.5 Utilisation et emploi soigneux d'outils électroportatifs
- 22.6 Utilisation et emploi soigneux d'outils électroportatifs sans fil
- 22.7 Service après-vente
- 22.8 Consignes de sécurité applicables aux taille-haies
- 1 Premessa
- 2 Informazioni sulle presenti Istruzioni d’uso
- 3 Sommario
- 4 Avvertenze di sicurezza
- 4.1 Simboli di avvertimento
- 4.2 Impiego secondo la destinazione
- 4.3 Requisiti dell'utente
- 4.4 Abbigliamento ed equipaggiamento
- 4.5 Zona di lavoro e area circostante
- 4.6 Condizioni di sicurezza
- 4.7 Impiego
- 4.8 Carica
- 4.9 Collegamento elettrico
- 4.10 Trasporto
- 4.11 Conservazione
- 4.12 Pulizia, manutenzione e riparazione
- 5 Preparare il tagliasiepi per l'esercizio
- 6 Carica della batteria e LED
- 7 Inserire e togliere la batteria
- 8 Accendere e spegnere il tagliasiepi
- 9 Controllo di tagliasiepi e batteria
- 10 Lavorare con il tagliasiepi
- 11 Dopo il lavoro
- 12 Trasporto
- 13 Conservazione
- 14 Pulizia
- 15 Manutenzione
- 16 Riparazione
- 17 Eliminazione dei guasti
- 18 Dati tecnici
- 19 Ricambi e accessori
- 20 Smaltimento
- 21 Dichiarazione di conformità UE
- 22 Avvertenze di sicurezza generali per attrezzi elettrici
- 1 Voorwoord
- 2 Informatie met betrekking tot deze handleiding
- 3 Overzicht
- 4 Veiligheidsinstructies
- 5 Heggenschaar klaar maken voor gebruik
- 6 Accu laden en leds
- 7 Accu aanbrengen en wegnemen
- 8 Heggenschaar inschakelen en uitschakelen
- 9 Heggenschaar en accu controleren
- 10 Met de heggenschaar werken
- 11 Na de werkzaamheden
- 12 Vervoeren
- 13 Opslaan
- 14 Reinigen
- 15 Onderhoud
- 16 Repareren
- 17 Storingen opheffen
- 18 Technische gegevens
- 19 Onderdelen en toebehoren
- 20 Milieuverantwoord afvoeren
- 21 EU-conformiteitsverklaring
- 22 Algemene veiligheidswaarschuwingen voor elektrische gereedschappen
► Do not operate the charger in a flammable
environment or in an explosive environ‐
ment.
►
Do not operate the charger on a readily
combustible surface.
► Use and store the charger at temperatures
between + 5 °C and + 40 °C.
■ The connecting cable is a trip hazard. People
may be injured and the charger may be dam‐
aged.
►
Lay the connecting cable flat on the floor.
4.6 Safe Condition
4.6.1 Hedge trimmer
The hedge trimmer is in a safe condition if the
following conditions are fulfilled:
–
The hedge trimmer is undamaged.
–
Hedge trimmer is clean and dry.
–
The controls function properly and have not
been modified.
–
The cutting blades are correctly fitted.
–
Only an original STIHL accessory for this
hedge trimmer has been fitted.
–
The accessories are correctly attached.
WARNING
■ If not in safe condition, components may no
longer operate correctly and safety devices
may be disabled. This may result in serous or
fatal injury to people.
►
Never use a damaged hedge trimmer.
► If the hedge trimmer is dirty or wet: Clean
the hedge trimmer and allow it to dry.
► Do not modify the hedge trimmer.
► If the controls do not work: Do not operate
the hedge trimmer.
► Only fit original STIHL accessories for this
hedge trimmer.
► Attach accessories as described in this
User Manual or in the User Manual for the
accessories.
►
Do not insert objects into the openings in
the hedge trimmer.
► Replace worn or damaged labels.
► If you have any doubts, be sure to consult a
STIHL dealer.
4.6.2 Cutting Blades
The cutting blades are in a safe condition if the
following points are observed:
–
Cutting blades are undamaged.
–
Cutting blades are not deformed.
–
Cutting blades move freely.
–
Cutting blades are properly sharpened.
–
Cutting blades have no burrs.
WARNING
■ If they are in an unsafe condition, parts of the
cutting blades may come off and be thrown at
high speed. This can result in serious injuries.
►
Work only with undamaged cutting blades.
► Make sure the cutting blades are properly
sharpened and deburred.
► If you have any queries: Contact your
STIHL servicing dealer.
4.6.3 Battery
The battery is in safe condition when the follow‐
ing conditions are met:
–
The battery is not damaged.
–
The battery is clean and dry.
–
The battery is working and has not been modi‐
fied.
WARNING
■ The battery cannot function safely if it is not in
safe condition. There is a risk of serious injury
to persons.
►
Use an undamaged and functioning battery.
► Do not charge a damaged or defective bat‐
tery.
► If the battery is dirty or wet: clean the bat‐
tery and allow it to dry.
► Do not modify the battery.
► Do not insert objects into the apertures in
the battery.
► Never connect the battery terminals to met‐
allic objects and cause a short circuit.
► Do not open the battery.
► Replace worn or damaged warning signs.
■ Fluid may leak from a damaged battery. If the
fluid contacts the skin or eyes, this may cause
irritation.
►
Avoid contact with the fluid.
► In the event of contact with the skin: wash
the affected areas with plenty of soap and
water.
►
In the event of contact with the eyes: rinse
the eyes with plenty of water for at least 15
minutes and seek medical attention.
■
A damaged or defective battery may emit an
unusual odour, smoke or catch fire. This may
result in serious or fatal injury to people and
damage to property.
►
If the battery emits an unusual odour or
smoke: do not use the battery and keep it
away from flammable materials.
►
If the battery catches fire: try to extinguish
the battery using a fire extinguisher or
water.
English 4 Safety Precautions
28 0458-714-9621-C