Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 General Power Tool Safety Warnings
- 6 IMPORTANT SAFETY INSTRUCTIONS
- 7 Charger Safety
- 8 Maintenance, Repair and Storage
- 9 Before Starting Work
- 10 Charging the Hedge Trimmer
- 11 LED Diagnostics
- 12 Inserting and Removing the Activation Key
- 13 Switching the Hedge Trimmer On and Off
- 14 Checking the Controls
- 15 During Operation
- 16 After Finishing Work
- 17 Transporting the Hedge Trimmer
- 18 Storing the Hedge Trimmer and Charger
- 19 Cleaning
- 20 Inspection and Maintenance
- 21 Troubleshooting Guide
- 22 Specifications
- 23 Replacement Parts and Equipment
- 24 Disposal
- 25 Limited Warranty
- 26 Trademarks
- 27 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 Advertencias generales de seguridad para herramientas motorizadas
- 6 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 7 Seguridad del cargador
- 8 Mantenimiento, reparación y almacenamiento
- 9 Antes de empezar a trabajar
- 10 Carga del cortasetos
- 11 Diagnóstico de LED
- 12 Inserción y retiro de la llave de activación
- 13 Encendido y apagado del cortasetos
- 14 Revisión de los controles
- 15 Durante el funcionamiento
- 16 Después de completar el trabajo
- 17 Transporte del cortasetos
- 18 Almacenamiento del cortasetos y el cargador
- 19 Limpieza
- 20 Inspección y mantenimiento
- 21 Guía de solución de problemas
- 22 Especificaciones
- 23 Piezas y equipos de repuesto
- 24 Eliminación
- 25 Garantía limitada
- 26 Marcas comerciales
- 27 Direcciones
0458-717-8621-A
27
English
20 Inspection and Maintenance
To sharpen the cutting blades with a file:
► Sharpen each cutting edge of the upper cutting blade with
a sharpening file. Always file toward the cutting edge with
a forward motion matching the sharpening angle, @ 22.2.
Sharpen on the forward stroke. Lift off the blade on the
backstroke.
► Only sharpen the cutting edges. Do not file blunt
projecting parts of the cutting attachment, or the cutting
blade guard. Make sure your sharpening stroke matches
the sharpening angle, @ 22.2.
► Turn the hedge trimmer over and sharpen the cutting
edges of the lower cutting blade.
► Use a whetstone to remove any burrs from the cutting
edges. Remove as little material as possible.
► After sharpening, wipe away filing or grinding dust with a
dry or slightly dampened cloth and then spray the cutting
blades with a resin solvent, such as STIHL Resin
Remover and Lubricant.
If you make a warranty claim for a component that has not
been serviced or maintained properly, coverage may be
denied.
NOTICE
Operating the machine with dull or damaged cutting blades
may overload the motor. Keeping the cutting blades sharp
helps maintain cutting performance and the expected life of
the product.
0000-GXX-1426-A0