Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 General Power Tool Safety Warnings
- 6 IMPORTANT SAFETY INSTRUCTIONS
- 7 Charger Safety
- 8 Maintenance, Repair and Storage
- 9 Before Starting Work
- 10 Charging the Hedge Trimmer
- 11 LED Diagnostics
- 12 Inserting and Removing the Activation Key
- 13 Switching the Hedge Trimmer On and Off
- 14 Checking the Controls
- 15 During Operation
- 16 After Finishing Work
- 17 Transporting the Hedge Trimmer
- 18 Storing the Hedge Trimmer and Charger
- 19 Cleaning
- 20 Inspection and Maintenance
- 21 Troubleshooting Guide
- 22 Specifications
- 23 Replacement Parts and Equipment
- 24 Disposal
- 25 Limited Warranty
- 26 Trademarks
- 27 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 Advertencias generales de seguridad para herramientas motorizadas
- 6 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 7 Seguridad del cargador
- 8 Mantenimiento, reparación y almacenamiento
- 9 Antes de empezar a trabajar
- 10 Carga del cortasetos
- 11 Diagnóstico de LED
- 12 Inserción y retiro de la llave de activación
- 13 Encendido y apagado del cortasetos
- 14 Revisión de los controles
- 15 Durante el funcionamiento
- 16 Después de completar el trabajo
- 17 Transporte del cortasetos
- 18 Almacenamiento del cortasetos y el cargador
- 19 Limpieza
- 20 Inspección y mantenimiento
- 21 Guía de solución de problemas
- 22 Especificaciones
- 23 Piezas y equipos de repuesto
- 24 Eliminación
- 25 Garantía limitada
- 26 Marcas comerciales
- 27 Direcciones
0458-717-8621-A
24
English
16 After Finishing Work
16.1 Preparing for Transportation or Storage
WARNING
To reduce the risk of personal injury from unintended
activation or unauthorized use, switch off the motor, ensure
the cutting blades have stopped and remove the activation
key before transporting the hedge trimmer or putting it down.
To prepare the hedge trimmer for transportation or storage:
► Switch off the hedge trimmer, @ 13.2.
► Remove the activation key, @ 12.2.
► Slide a blade scabbard over the cutting blades so that it
covers the entire cutting attachment.
► If the hedge trimmer became wet during operation, allow
it to dry completely before charging or storing.
17.1 Hedge Trimmer
WARNING
To reduce the risk of personal injury from unintended
activation, never transport the hedge trimmer with the
activation key inserted.
When transporting the hedge trimmer:
► Slide a blade scabbard over the cutting blades so that it
covers the entire cutting attachment.
► When transporting the hedge trimmer by hand, hold it by
the loop handle with the cutting blades pointing
backwards, opposite the direction in which you are
walking.
► When transporting the hedge trimmer in a vehicle, cover
the entire length of the cutting blades with a blade
scabbard. Secure and position the hedge trimmer to
prevent turnover, impact and damage.
Your hedge trimmer comes standard with a blade scabbard.
A Note on Battery Transport
The battery inside this hedge trimmer complies with the
requirements set forth in UN-Manual ST/SG/AC.10/11/
Rev.5/Part III, Subsection 38.3.
Commercial air, vessel and ground transportation of lithium
ion cells and batteries contained in equipment is regulated.
The battery inside this hedge trimmer is classified as a UN
3481, Class 9, packaging group II product. Shipping it
requires compliance with all applicable shipping regulations.
Check with the ground, vessel, air cargo or passenger airline
to determine if transport is prohibited or subject to
restrictions or exemptions prior to shipping or travel.
Normally, no further conditions have to be met by the user in
order to transport this hedge trimmer by road to the
operating site. Check and comply with any special
regulations that may apply to your situation.
16 After Finishing Work
17 Transporting the Hedge Trimmer
0000-GXX-2048-A0