Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 General Power Tool Safety Warnings
- 6 IMPORTANT SAFETY INSTRUCTIONS
- 7 Charger Safety
- 8 Maintenance, Repair and Storage
- 9 Before Starting Work
- 10 Charging the Hedge Trimmer
- 11 LED Diagnostics
- 12 Inserting and Removing the Activation Key
- 13 Switching the Hedge Trimmer On and Off
- 14 Checking the Controls
- 15 During Operation
- 16 After Finishing Work
- 17 Transporting the Hedge Trimmer
- 18 Storing the Hedge Trimmer and Charger
- 19 Cleaning
- 20 Inspection and Maintenance
- 21 Troubleshooting Guide
- 22 Specifications
- 23 Replacement Parts and Equipment
- 24 Disposal
- 1 Préface
- 2 Indications concernant la présente Notice d'emploi
- 3 Principales pièces
- 4 Symboles de sécurité sur les produits
- 5 Indications générales de sécurité pour outils électroportatifs
- 6 CONSIGNES DE SÉCURITÉ IMPORTANTES
- 7 Sécurité du chargeur
- 8 Maintenance, réparation et rangement
- 9 Avant d'entreprendre le travail
- 10 Charge du taille-haies
- 11 Diagnostic à l'aide des DEL
- 12 Insertion et retrait de la clé d’activation
- 13 Mise en marche et arrêt du taille-haies
- 14 Vérification des commandes
- 15 Pendant l’utilisation
- 16 Après avoir terminé le travail
- 17 Transport du taille-haies
- 18 Entreposage du taille-haies et du chargeur
- 19 Nettoyage
- 20 Inspection et maintenance
- 21 Guide de dépannage
- 22 Spécifications
- 23 Pièces de rechange et équipement
- 24 Élimination
0458-717-8221-A
28
English
21 Troubleshooting Guide
21.1 Troubleshooting
21 Troubleshooting Guide
Always remove the activation key before carrying out any inspection, cleaning or maintenance.
Condition LEDs on the
Hedge Trimmer
Cause Remedy
3 LEDs flash
red.
Malfunction in hedge
trimmer.
► Do not attempt to use. The hedge trimmer has a malfunction
and must be checked by a servicing dealer.
Hedge trimmer does
not start when
switched on.
Activation key not
fully inserted.
► Remove the activation key, @ 12.2.
► Visually check the electrical contacts of the activation key.
► Reinsert the activation key, @ 12.1.
1 LED flashes
green.
Less than 20%
charge remaining.
► Charge the hedge trimmer, @ 10.
3 LEDs glow
red.
Integrated battery
too hot.
► Remove the activation key, @ 12.2.
► Allow the hedge trimmer to cool down gradually at ambient
temperatures of about 50°F to 68°F (10°C to 20°C).
Moisture in hedge
trimmer.
► Allow the hedge trimmer to dry.
Hedge trimmer cuts
out during operation.
3 LEDs glow
red.
Integrated battery
too hot.
► Remove the activation key, @ 12.2.
► Allow the hedge trimmer to cool down gradually at ambient
temperatures of about 50°F to 68°F (10°C to 20°C).
Electrical
malfunction.
► Switch off the hedge trimmer. Wait at least 5seconds and
switch it back on, @ 13.
Runtime is too short. Hedge trimmer not
fully charged.
► Charge the hedge trimmer, @ 10.
Useful life of
integrated battery
has been reached or
exceeded.
► Have the hedge trimmer checked by an authorized STIHL
servicing dealer.
Integrated battery
too hot / too cold.
► Allow the hedge trimmer to warm up or cool down gradually
at ambient temperatures of about 50°F to 68°F (10 °C to
20°C).
Hedge trimmer is not
being charged.
3 LEDs glow
red.
Integrated battery
too hot / too cold.
► Allow the hedge trimmer to warm up or cool down gradually
at ambient temperatures of about 50°F to 68°F (10 °C to
20°C).
► Operate the charger only in enclosed, dry rooms at ambient
temperatures of 32°F to 104°F (0°C to 40°C).