Instruction Manual

0458-717-8221-A
15
English 6 IMPORTANT SAFETY INSTRUCTIONS
￭ To reduce the risk of severe personal injuries from
unintentional starting:
– Never touch the cutting blades with your hand or any
other part of your body when the activation key is
inserted, even when the cutting blades are not
moving.
￭ The cutting blades continue to move for a short period
after the trigger switch or switch lever is fully released.
– Wait for the cutting blades to stop before walking
with the hedge trimmer or putting it down.
￭ In the event of an emergency:
– Switch off the motor immediately and remove the
activation key.
￭ Contacting foreign objects while cutting could damage the
cutting blades and may cause them to crack, chip, break
or jam. To reduce the risk of severe personal injury or
death from loss of control, and to reduce the risk of
damage to the hedge trimmer:
– Inspect the material to be cut and the surrounding
area for stones, fence wire, metal or other foreign
objects before starting work.Do not use the hedge
trimmer in areas where the cutting blades could
contact such objects.
– Take particular care when cutting next to, against or
near wire fences. Do not touch the wire with the
cutting blades.
– When working close to the ground, make sure that
no sand, grit or stones get between the cutting
blades.
– Do not cut any areas of the hedge, bush, shrub or
other vegetation that you cannot see.
￭ To reduce the risk of injury to bystanders:
– Do not allow other persons in the general work area.
– If cutting the top of a taller hedge, check the other
side of the hedge frequently for bystanders, animals
and obstructions.
￭ Check the cutting blades at regular short intervals during
operation, or immediately if there is a change in cutting
behavior:
– Switch off the hedge trimmer and remove the
activation key.
– Check the condition, tightness and sharpness of the
cutting blades.
– Keep hands, feet and other body parts
away from the cutting blades.
– Do not touch the cutting blades while the
activation key is inserted.
– Never touch moving cutting blades with
your hand or any other part of your body.
– Never hold the material to be cut or
attempt to remove cut material without
first releasing the trigger switch and
removing the activation key.
– Release the trigger switch and remove
the activation key before clearing
jammed material.
– If the cutting blades become jammed by
branches or other obstructions, switch
off the hedge trimmer immediately and
remove the activation key before
attempting to free the blades.