Operation Manual

0458-708-0121-A
17
English 12 After Finishing Work
► Hold the shrub shears at the required height while cutting
the grass.
12.1 After Finishing Work
► Switch off the shrub shears and remove the battery.
► If the shrub shears are wet: Allow the shrub shears to dry.
► Clean the shrub shears.
► Clean the cutting blades.
► Fit the blade scabbard so that it completely covers the
cutting blades.
► Clean the battery.
13.1 Transporting the Shrub Shears
► Switch off the shrub shears and remove the battery.
► Fit the blade scabbard so that it completely covers the
cutting blades.
► Carry the shrub shears by the control handle.
► Transporting the shrub shears in a vehicle: Secure the
shrub shears to prevent them turning over or shifting.
13.2 Transporting the Battery
► Switch off the shrub shears and remove the battery.
► Make sure the battery is in a safe condition.
► Observe the following points when packing the battery:
– The packaging must be non-conductive.
– Make sure the battery cannot shift inside the packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the requirements for the transport
of dangerous goods. The battery is classified as UN 3480
(lithium-ion batteries) and has been tested in accordance
with UN Manual of Tests and Criteria, Part III, sub-section
38.3.
For transport regulations see www.stihl.com/safety-data-
sheets
14.1 Storing the Shrub Shears
► Switch off the shrub shears and remove the battery.
► Fit the blade scabbard so that it completely covers the
cutting blades.
► Observe the following points when storing the shrub
shears:
– The shrub shears are out of the reach of children.
– The shrub shears are clean and dry.
14.2 Storing the Battery
► Observe the following points when storing the battery:
– Battery is out of the reach of children.
– Battery is clean and dry.
– Battery is in an enclosed location.
– Battery is stored separately from the shrub shears and
charger.
– Battery is in non-conductive packaging.
– Battery is in a temperature range between -10°C and
+40°C.
14.3 Storing the Charger
► Disconnect the plug from the wall outlet.
► Remove the battery.
► Observe the following points when storing the charger:
– Charger is out of the reach of children.
– Charger is clean and dry.
12 After Finishing Work
13 Transporting
14 Storing