Instruction Manual

HS 46, HS 46 C, HS 56 C
English
16
hex key to distribute the grease
evenly – avoid contact with the
cutting blades.
NOTICE
Do not completely fill the gearbox with
grease.
N Fit the retaining plate (2) so that it is
flush with the gearbox housing.
N Fit the gearbox cover (3), insert the
screws (1) and tighten them down
firmly.
HS 56
Use STIHL gear lubricant for hedge
trimmers (special accessory) to lubricate
the blade drive gear.
N Unscrew the filler plug (1). If no
grease can be seen on the inside of
the filler plug, screw the tube (2) of
STIHL gear lubricant (special
accessory) into the filler hole.
N Squeeze up to 5 g (1/5 oz) grease
into the gearbox.
NOTICE
Do not completely fill the gearbox with
grease.
N Unscrew the tube of grease from the
filler hole.
N Refit the filler plug and tighten it
down firmly.
For periods of 3 months or longer
N Clean the cutting blades, check
condition and spray them with
STIHL resin solvent.
N Drain and clean the fuel tank in a
well ventilated area.
N Dispose of fuel properly in
accordance with local
environmental requirements.
N Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N Fit the blade scabbard.
N Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
N Store the machine in a dry and safe
location (use the ring integrated in
the rear handle) – out of the reach of
children and other unauthorized
persons.
2
0000-GXX-3987-A0
1
3
1
1
1
0000-GXX-3952-A0
1
2
Storing the Machine