Instruction Manual

HS 46, HS 46 C, HS 56 C
English
12
Start the engine.
N Press the manual fuel pump bulb at
least five times – even if the bulb is
filled with fuel.
N Set the Master Control lever to suit
the engine temperature.
Cold engine (cold start)
N Depress the throttle trigger
lockout (1) and the throttle
trigger (2) at the same time – hold
both levers in that position.
N Move the Master Control lever (3) to
l.
N Release the throttle trigger
lockout (1), throttle trigger (2) and
Master Control lever.
Warm engine (warm start)
N Depress the throttle trigger
lockout (1) and the throttle
trigger (2) at the same time – hold
both levers in that position.
N Move the Master Control lever (3) to
n.
N Release the throttle trigger
lockout (1), throttle trigger (2) and
Master Control lever.
Also use this setting if the engine has
been running but is still cold.
Starting
N Place the unit on the ground.
N Remove the blade scabbard. Check
that the cutting blades are not
touching the ground or any other
obstacles.
N Make sure you have a safe and
secure footing.
N Hold the unit firmly with your left
hand on the fan housing and press
down.
N Hold the starter grip with your right
hand.
Version without ErgoStart
N Pull the starter grip slowly until you
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Version with ErgoStart
N Pull the starter grip steadily.
As soon as the engine runs
N Press down the throttle trigger
lockout and open the throttle – the
Master Control lever moves to the
0008BA008 KN
3
0008BA009 KN
1
2
3
0008BA010 KN
1
2
0008BA011 KN
0008BA012 KN