Instruction Manual

0458-185-8621-A
20
English 9 Before Starting Work
9.1 Preparing the Hedge Trimmer for Operation
Before starting work:
► Fully charge the battery, @ 10.2.
► Mount the loop handle (HLA 66 only), @ 13.1.
► Adjust the angle of the cutting blades, @ 17.1.
► Adjust the length of the drive tube (HLA 86 only), @ 17.2.
► Put on and adjust the harness, @ 17.3.
► Check the controls for proper function and condition,
@ 16.1.
► Check the cutting attachment for damage or other
problems.
10.1 Setting up the Charger
WARNING
Read and follow the safety precautions on the battery and
charger and all warnings and instructions that accompany
those products. To reduce the risk of short circuit, which
could lead to electric shock, fire and explosion, make sure
the charger and its components are dry and not damaged;
operate the charger indoors at an appropriate ambient
temperature.
WARNING
A typical household electric circuit is between 15 and 20
amps. A single STIHL AL 500 charger draws approximately
4.8 amps. A single AL 300 charger draws approximately
4.4 amps. To reduce the risk of fire from overloading an
electrical circuit:
► Ensure the electrical system is rated to withstand the
expected electrical draw before charging your battery.
► Charge multiple batteries one at a time or on separate
circuits, unless you know your circuit can handle the total
expected draw from multiple chargers.
WARNING
Since the charger heats up during the charging process, do
not operate the charger on a combustible surface or in a
location where combustible gases, liquids, vapors, dusts or
other materials and substances are present.
To set up the charger:
► Insert the plug (3) into a properly installed electrical
outlet (4) matching the voltage and electrical frequency
stated on the rating plate on the charger.
The charger runs a self-test immediately after it is plugged
in. The charger LED (1) will glow green for about 1 second,
then it will glow red briefly before going out. Once the LED
goes out, the self-test is complete and the charger is ready
to charge the battery.
9 Before Starting Work
10 Charging the Battery
3
2
0000-GXX-3228-A1
4
1