Instruction Manual

HLA 65, HLA 85
English
22
N Turn screw (2) slowly clockwise as
far as stop – the lever must move
freely to closed position. If not, the
clamping force is too high.
N Close lever (1) and press it home as
far as stop – the clamping force is
too high if the lever does not locate
against the stop.
N Check clamping force.
If clamping force is too low:
N Carefully turn screw (2) clockwise a
1/4 turn at a time – this increases
the clamping force.
If clamping force is too high:
N Carefully turn screw (2)
counterclockwise a 1/4 turn at a
time – this reduces the clamping
force.
The type of harness is market-specific.
Shoulder Strap
Versions without telescoping shaft
N Put on the shoulder strap (1).
N Adjust the length of the strap so that
the carabiner (2) is about a hand’s
width below your right hip.
Versions with telescoping shaft
N Put on the shoulder strap (1).
N Adjust the length of the strap so that
the carabiner (2) is about a hand’s
width below your right hip.
Attaching Machine to Harness
N Attach the carabiner (1) to the
carrying ring (2) on the drive tube.
0022BA020 AS
2
1
Fitting the Harness
1
2
4866BA017 KN
2
1
7126BA004 KN
1
002BA320 KN
2
1
2