Instruction Manual

HLA 65, HLA 85
English
21
N Switch off the machine, move the
retaining latch to ƒ and remove the
battery.
N Fit the blade scabbard.
N Pull back the sliding sleeve (1) and
use the swivel handle (2) to swing
the joint downwards – in direction of
drive tube – until the cutter bar is flat
against the drive tube.
N Release the sliding sleeve (1) and
allow lock pin to engage the hole in
the housing.
The sliding sleeve butts against the
housing when the pin is properly
engaged (after making adjustment).
HLA 85 only
WARNING
Always switch off the power tool and
move the retaining latch to ƒ.
N Open lever (1) of quick-release
clamp and swing it back as far as it
will go.
N Adjust shaft to the required length.
N Close the lever (1) and press it
down as far as stop.
N Check clamping force – if it is too
low: go to "Adjusting Clamping
Force".
The clamping force is correct when the
shaft is firmly locked in position with the
quick-release clamp closed.
Adjusting clamping force
N Swing lever (1) of quick-release
clamp up to 90° position.
4866BA014 KN
1
2
Adjusting the Telescoping
Shaft
180°
1
0022BA019 AS
7126BA008 KN
1
90°
1
0022BA029 AS