Instruction Manual

HLA 65, HLA 85
English
16
Mounting the loop handle
Only versions without telescoping shaft
N Place the clamp (1) in the loop
handle (2) and position them both
against the shaft (5) between the
carrying ring (3) and handle
hose (4).
N Position the clamp (6) against the
shaft.
N Line up the holes.
N Insert the screws (7) with
washers (8).
N Fit the square nuts (9) and screw
home the screws.
N Line up the loop handle.
N Tighten down the screws firmly.
Power supply (mains) voltage and
operating voltage must be the same.
N Insert the plug (1) in the wall
outlet (2).
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
Assembling the Unit
4
7
8
2
4866BA016 KN
1
6
7
8
9
9
3
Connecting Charger to
Power Supply
3901BA015 KN
2
1
1
3901BA019 KN