Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing Hedge Trimmer for Operation
- 6 Charging the Battery, LEDs
- 7 Assembling the Hedge Trimmer
- 8 Removing and Fitting the Battery
- 9 Switching the Hedge Trimmer On/Off
- 10 Testing the Hedge Trimmer and Battery
- 11 Operating the Hedge Trimmer
- 12 After Finishing Work
- 13 Transporting
- 14 Storing
- 15 Cleaning
- 16 Maintenance
- 17 Repairing
- 18 Troubleshooting
- 19 Specifications
- 20 Spare Parts and Accessories
- 21 Disposal
- 22 EC Declaration of Conformity
- 23 General Power Tool Safety Warnings

0458-816-8321-A
19
English
17 Repairing
► Use a STIHL flat crosscut file to sharpen each cutting
edge on the upper blade. The file only sharpens on the
forward stroke. Maintain the prescribed sharpening angle,
@ 19.2.
► Turn the hedge trimmer over.
► Deburr each cutting edge from below.
► Use a damp cloth to remove the filing dust.
► Spray both sides of blades with STIHL resin solvent.
► Switch on the hedge trimmer for 5 seconds.
The cutting blades run. STIHL resin solvent is distributed
evenly.
► If you have any queries: Contact your STIHL servicing
dealer for assistance.
17.1 Repairing the Hedge Trimmer and Battery
The hedge trimmer, cutting blades and battery cannot be
repaired by the user.
► If the hedge trimmer or cutting blades are damaged: Do
not use your hedge trimmer and contact your STIHL
servicing dealer.
► If the battery has a malfunction or is damaged: Replace
the battery.
17 Repairing










