Instruction Manual

0458-816-8321-A
16
English 12 After Finishing Work
Cutting side of hedge
► Use lopping shears or a chainsaw to cut out thick
branches first.
► If you have to cut at a certain distance from the hedge
(flowerbed): Set the cutter bar to a suitable angle.
► Swing the hedge trimmer from the bottom upwards in an
arc while making the cut.
► Walk slowly and steadily forwards.
► Cut the other side of the hedge in the same way.
► If cutting performance deteriorates: Sharpen the cutting
blades.
Cutting top of hedge
► Use lopping shears or a chainsaw to cut out thick
branches first.
► Hold the cutting blades at an angle of 0° to 10° to the top
of the hedge.
► Swing the hedge trimmer horizontally and in an arc while
making the cut.
► If cutting performance deteriorates: Sharpen the cutting
blades.
Cutting overhead
► Use lopping shears or a chainsaw to cut out thick
branches first.
► Set the cutter bar to a suitable angle.
► Hold the cutting blades at an angle of 0° to 10° to the top
of the hedge.
► Swing the hedge trimmer horizontally and in an arc while
making the cut.
► If cutting performance deteriorates: Sharpen the cutting
blades.
12.1 After Finishing Work
► Switch off the hedge trimmer and remove the battery.
► If the hedge trimmer is wet: Allow the hedge trimmer to
dry.
► Clean the hedge trimmer.
► Clean the cutting blades.
► Fit the blade scabbard so that it completely covers the
cutting blades.
0000-GXX-4574-A0
0000-GXX-4575-A0
12 After Finishing Work
0000-GXX-7607-A0