Instruction Manual

Table Of Contents
0458-816-9821-B
46
English
12 After Finishing Work
Hold the cutting blades at an angle of 0° to 10° to the top
of the hedge.
Swing the hedge trimmer horizontally and in an arc while
making the cut.
If cutting performance deteriorates: Sharpen the cutting
blades.
12.1 After Finishing Work
Switch off the hedge trimmer and remove the battery.
If the hedge trimmer is wet: Allow the hedge trimmer to
dry.
Clean the hedge trimmer.
Clean the cutting blades.
Fit the blade scabbard so that it completely covers the
cutting blades.
Clean the battery.
13.1 Transporting the Hedge Trimmer
Switch off the hedge trimmer and remove the battery.
Fit the blade scabbard so that it completely covers the
cutting blades.
Rotate the wing screw (3) counterclockwise.
Pull the cutting blades (2) out of the coupling sleeve (1).
Carry the cutter bar in one hand with the cutting blades
behind you.
Transporting the hedge trimmer in a vehicle: Secure the
hedge trimmer so that it cannot turn over or move.
13.2 Transporting the Battery
Switch off the hedge trimmer and remove the battery.
Make sure the battery is in a safe condition.
Observe the following points when packing the battery:
The packaging must be non-conductive.
Make sure the battery cannot shift inside the packaging.
Secure the packaging so that it cannot move.
The battery is subject to the requirements for the transport
of dangerous goods. The battery is classified as UN 3480
(lithium-ion batteries) and has been tested in accordance
with UN Manual of Tests and Criteria, Part III, sub-section
38.3.
For transport regulations see www.stihl.com/safety-data-
sheets
12 After Finishing Work
13 Transporting
2
1
3
0000-GXX-7608-A0