Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing Hedge Trimmer for Operation
- 6 Charging the Battery, LEDs
- 7 Assembling the Hedge Trimmer
- 8 Removing and Fitting the Battery
- 9 Switching the Hedge Trimmer On/Off
- 10 Testing the Hedge Trimmer and Battery
- 11 Operating the Hedge Trimmer
- 12 After Finishing Work
- 13 Transporting
- 14 Storing
- 15 Cleaning
- 16 Maintenance
- 17 Repairing
- 18 Troubleshooting
- 19 Specifications
- 20 Combinations of Carrying Systems
- 21 Spare Parts and Accessories
- 22 Disposal
- 23 EC Declaration of Conformity
- 24 General Power Tool Safety Warnings
0458-683-0121-A
17
English
11 Operating the Hedge Trimmer
► Pull back the sliding sleeve (1) and hold it there.
► Grip the swivel handle (2) and swing cutting blade to
required angle.
► Release the sliding sleeve (1).
► Move swivel handle (2) back and forth until the sliding
sleeve (1) engages.
The sliding sleeve (1) butts against the housing. You have
adjusted the angle of the cutting blades.
► Check that the swivel handle (2) cannot be pushed in or
pulled out any more.
11.2 Fitting and Adjusting the Shoulder Strap
► Put on the shoulder strap (1).
► Adjust the shoulder strap (1) so that the carabiner (2) is
about a hand’s width below your right hip.
Other approved carrying systems are listed in this User
Manual, @ 20.
11.3 Holding and controlling the long-reach hedge
trimmer
► Connect the carrying ring (2) to the carabiner (1).
► Hold the long-reach hedge trimmer with one hand on the
control handle and clasp the control handle with your
thumb.
► Hold the long-reach hedge trimmer firmly with your other
hand on the handle hose and clasp the handle hose with
your thumb.
1
2
55°
90°
0000097313_001
2
1
0000-GXX-2990-A0
2
1
0000-GXX-7807-A1
0000097178_001