Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 General Power Tool Safety Warnings
- 6 IMPORTANT SAFETY INSTRUCTIONS
- 7 Battery Safety
- 8 Maintenance, Repair and Storage
- 9 Before Starting Work
- 10 Charging the Battery
- 11 LED Diagnostics and Acoustic Signals
- 12 STIHL AR Backpack Battery
- 13 Assembling the Hedge Trimmer
- 14 Inserting and Removing the Battery
- 15 Switching the Hedge Trimmer On and Off
- 16 Checking the Controls
- 17 During Operation
- 18 After Finishing Work
- 19 Transporting the Hedge Trimmer and Battery
- 20 Storing the Hedge Trimmer and Battery
- 21 Cleaning
- 22 Inspection and Maintenance
- 23 Troubleshooting Guide
- 24 Specifications
- 25 Approved Harness Combinations
- 26 Replacement Parts and Equipment
- 27 Disposal
- 28 Limited Warranty
- 29 Trademarks
- 30 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 Advertencias generales de seguridad para herramientas motorizadas
- 5.1 Introducción
- 5.2 Seguridad en la zona de trabajo
- 5.3 Seguridad eléctrica
- 5.4 Seguridad personal
- 5.5 Uso y cuidado de la herramienta motorizada
- 5.6 Uso y cuidado de la herramienta con batería
- 5.7 Mantenimiento
- 5.8 Advertencias de seguridad del cortasetos
- 5.9 Advertencias de seguridad del cortasetos de alcance extendido
- 6 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 7 Seguridad de la batería
- 8 Mantenimiento, reparación y almacenamiento
- 9 Antes de empezar a trabajar
- 10 Carga de la batería
- 11 Diagnóstico por LED y señales acústicas
- 12 Batería de mochila STIHL AR
- 13 Armado del cortasetos
- 14 Colocación y extracción de la batería.
- 15 Encendido y apagado del cortasetos
- 16 Revisión de los controles
- 17 Durante el funcionamiento
- 18 Después de completar el trabajo
- 19 Transporte del cortasetos y de la batería
- 20 Almacenamiento del cortasetos y de la batería
- 21 Limpieza
- 22 Inspección y mantenimiento
- 23 Guía de solución de problemas
- 24 Especificaciones
- 25 Combinaciones de arnés aprobadas
- 26 Piezas y equipos de repuesto
- 27 Eliminación
- 28 Garantía limitada
- 29 Marcas comerciales
- 30 Direcciones
0458-683-8621-A
35
English
22 Inspection and Maintenance
► Do not use a pressure washer to clean the cutting blades
or spray them with water or other liquids.
21.3 Cleaning the Air Filter
To clean the air filter:
► Switch off the power tool, @ 15.2.
► Remove the battery, @ 14.2.
► Clean the area around the air filter (2) with a damp cloth
or soft brush.
► Turn the screw (1) counterclockwise until the air filter can
be removed.
► Remove the air filter by lifting it up and pulling it off.
► Rinse away coarse dirt from the outside of the air filter
under running water. Never spray the air filter with a
pressure washer.
► If the air filter is damaged, replace it.
► Allow the air filter to air dry.
► After the air filter has dried thoroughly, push it into place
by hand.
► Tighten the screw.
22.1 Inspecting and Maintaining the Hedge Trimmer
WARNING
To reduce the risk of personal injury from unintended
activation, remove the battery before inspecting the hedge
trimmer or carrying out any maintenance, @ 8.1. Carry out
only the maintenance operations described in this manual.
There are no user-authorized repairs. STIHL recommends
that repair work be performed by authorized STIHL servicing
dealers.
To properly maintain the hedge trimmer:
► Clean the air filter every 50 hours of operation.
► Sharpen the cutting blades.
► Lubricate the gearbox every 25 hours of operation.
► Have worn or damaged cutting blades replaced by an
authorized STIHL servicing dealer.
► Have worn, missing or damaged safety labels replaced by
an authorized STIHL servicing dealer.
If you make a warranty claim for a component that has not
been serviced or maintained properly, coverage may be
denied.
22.2 Inspecting and Maintaining the Cutting Blades
WARNING
To reduce the risk of personal injury from unintended
activation, remove the battery before inspecting the cutting
blades or carrying out any maintenance, @ 7.1. To help
prevent injuries, always wear heavy-duty work gloves when
handling the hedge trimmer or its cutting blades, @ 6.3.
STIHL recommends having the cutting blades sharpened by
an authorized STIHL servicing dealer.
Although it is best to have the cutting blades sharpened by
a dealer on a workshop sharpener, it is possible to use a flat
crosscut sharpening file.
0000097125-001
1
2
22 Inspection and Maintenance