Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 General Power Tool Safety Warnings
- 6 IMPORTANT SAFETY INSTRUCTIONS
- 7 Battery Safety
- 8 Maintenance, Repair and Storage
- 9 Before Starting Work
- 10 Charging the Battery
- 11 LED Diagnostics and Acoustic Signals
- 12 STIHL AR Backpack Battery
- 13 Assembling the Hedge Trimmer
- 14 Inserting and Removing the Battery
- 15 Switching the Hedge Trimmer On and Off
- 16 Checking the Controls
- 17 During Operation
- 18 After Finishing Work
- 19 Transporting the Hedge Trimmer and Battery
- 20 Storing the Hedge Trimmer and Battery
- 21 Cleaning
- 22 Inspection and Maintenance
- 23 Troubleshooting Guide
- 24 Specifications
- 25 Approved Harness Combinations
- 26 Replacement Parts and Equipment
- 27 Disposal
- 28 Limited Warranty
- 29 Trademarks
- 30 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 Advertencias generales de seguridad para herramientas motorizadas
- 5.1 Introducción
- 5.2 Seguridad en la zona de trabajo
- 5.3 Seguridad eléctrica
- 5.4 Seguridad personal
- 5.5 Uso y cuidado de la herramienta motorizada
- 5.6 Uso y cuidado de la herramienta con batería
- 5.7 Mantenimiento
- 5.8 Advertencias de seguridad del cortasetos
- 5.9 Advertencias de seguridad del cortasetos de alcance extendido
- 6 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 7 Seguridad de la batería
- 8 Mantenimiento, reparación y almacenamiento
- 9 Antes de empezar a trabajar
- 10 Carga de la batería
- 11 Diagnóstico por LED y señales acústicas
- 12 Batería de mochila STIHL AR
- 13 Armado del cortasetos
- 14 Colocación y extracción de la batería.
- 15 Encendido y apagado del cortasetos
- 16 Revisión de los controles
- 17 Durante el funcionamiento
- 18 Después de completar el trabajo
- 19 Transporte del cortasetos y de la batería
- 20 Almacenamiento del cortasetos y de la batería
- 21 Limpieza
- 22 Inspección y mantenimiento
- 23 Guía de solución de problemas
- 24 Especificaciones
- 25 Combinaciones de arnés aprobadas
- 26 Piezas y equipos de repuesto
- 27 Eliminación
- 28 Garantía limitada
- 29 Marcas comerciales
- 30 Direcciones
0458-683-8621-A
30
English
17 During Operation
► Hold the blade adjustment grip (2) firmly.
► Pull back the blade adjustment release (1) and hold it in
this unlocked position.
► Move the cutting blades to the desired angle.
► Release the blade adjustment release.
The blade adjustment release will spring back into place.
► Move the blade adjustment grip up and down until the
cutting blades engage.
That completes the adjustment.
► Confirm that the blade adjustment grip is fixed in place.
17.2 Putting on and Adjusting the Shoulder Strap
To fit and adjust the harness:
► Switch off the hedge trimmer, @ 15.2.
► Remove the battery, @ 14.2.
► Put the shoulder strap over your shoulder.
► Adjust the length of the shoulder strap (1) so that the
carabiner (2) is about a hand’s width below the top of your
hip.
► Attach the carabiner (1) to the carrying ring (2) on the
hedge trimmer.
17.3 Selecting the Power Level
The unit can be operated at three different power settings,
indicated by LEDs on the control handle. The higher the
power level, the faster the cutting blades will rotate.
To set the power level:
► Depress and hold the trigger switch lockout (1).
► While holding the trigger switch lockout, push the retaining
latch (2) forward with your thumb and release it.
The LEDs indicate the current power level.
► Push the retaining latch forward to activate the next power
level.
Performing this operation at the highest power level will
cause the unit to return to the first power level.
2
1
0000-GXX-2990-A0
2
1
0000-GXX-7807-A1
1
2
0000097314_001