Operation Manual

HL 92, HL 92 K
English
19
If there is a noticeable loss of engine
power
N Set knob for warm start (1) to g
N Turn screw (2) in filter cover (3)
counterclockwise until the cover is
loose
N Remove filter cover (3)
N Clean away loose dirt from around
the filter
N Grip into the recess (4) in the filter
housing and remove the felt filter (5)
N Replace felt filter (5) – as a
temporary measure you can knock it
out on the palm of you hand or blow
it out with compressed air – do not
wash
NOTICE
Replace any damaged parts!
N Insert felt filter (5) form-fittingly into
the filter housing
N Set knob for warm start (1) to g
N Fit filter cover (3) – make sure not to
tilt the screw (2) – insert screw and
tighten
The carburetor has been set at the
factory to provide an optimum fuel-air
mixture under most operating
conditions.
Adjusting Idle Speed
Engine stops while idling
N Turn the idle speed screw (LA)
slowly clockwise until the engine
runs smoothly.
Cutting blades run when engine is idling
N Turn the idle speed screw (LA)
slowly counterclockwise until the
cutting blades stop running.
WARNING
If the cutting blades continue moving
when the engine is idling, have your
power tool checked and repaired by your
servicing dealer.
Cleaning the Air Filter
0208BA034 KN
1
0208BA035 KN
5
4
Adjusting the Carburetor
0208BA036 KN